|09-02-2006 10:58 AM|
|QQQQ||The H&R frt. sway bar has two different hole locations in the end so you can adjust the length of the arm by bolting your sway bar link through either hole.|
|05-12-2006 02:41 PM|
24mm F&R makes my car feel so balanced with the Steeda Springs. I guess my car is more like a Lotus than a BMW!
Killer post! Good toilet-reading material!
|03-19-2006 02:55 AM|
|Oni||Not necessarily. The location of the bolts and mounting points for any aftermarket sway bar should match up to the OE unless fabrication is required. If the H&R sway bar were to have a longer moment arm, all it would simply do is readjust where the bar is located under the car by possibly a few centimeters. Basically, if you can imagine the OE bar is fixed but has some space around it, then the moment arm of the aftermarket sway bar can be lengthened or shortened as it has room to be moved forward and back in the empty space.|
|03-18-2006 10:33 PM|
|finalley||if the HR bolts back up to the stock location with the stock bolts wouldn't the arm length be the same??|
|03-18-2006 02:13 PM|
|dwdgsi03||Oh wow, so going to a 24mm H&R bar is going to make a WORLD of difference. Now I can see how just adding to the rear can disrupt the cars balance so much.|
|03-18-2006 02:08 PM|
|Oni||Is that a question or what? I know there are adjustable end links on some sway bars, but as far as I know, H&R's are fixed. I was stating I wonder if the moment arm on the H&R sway bar is the same as OE which would mean you'd only increase the stiffness of the bar through the diameter enlargement - not the moment arm increase in length and the diameter.|
|03-18-2006 07:50 AM|
|03-09-2006 09:02 AM|
Just as an interesting side note, Sway-bars are used by manufacturers in very different ways. BMW for instance, believes in stiffer springs/dampers with relatively weak sway-bars whereas Lotus uses a lot of sway bar with a relatively soft damper/spring setup. Both are great handlers, but shoot for the same goal with different methods.
So many people forget how much of an interconneted system it all is, but of course not many companies would sell (or customers would buy) nothing but a front to back full suspension upgrade... After all, even an upgrade in tires could totally change the TTLD.
|03-08-2006 10:21 PM|
|Oni||Excellent article. I wonder if SVT knows approximately what the precentage is for the stock TLLTD. I'd be interested to see what the H&R 24mm rear sway bar does for that factor since that's most likely the sway bar I will upgrade to. And I wonder if the moment arm is different in length than the OE.|
|03-08-2006 09:47 PM|
so much good info brain meltdown
|This thread has more than 10 replies. Click here to review the whole thread.|