|03-11-2006 11:41 AM|
actually, it's better to just hold the brake, then on the last yellow, let off the brake and mash the gas....
it's acutally better than loading the torque converter before hand, by holding the brakes and gas....
try a run both ways, see which works better for you...
|03-02-2006 08:21 PM|
|svtguy88||LMAO....no, not neutral drops.....the only thing that would be worse would be reverse drops.....I was talking about drag launching an ATX. lol|
|03-02-2006 08:07 PM|
|jaykirs||^^^ It is EXTREMELY hard on the tranny!!!! And on the engine mounts and the axels and the CV joints and the torque converter ..... it can easily destroy your tranny, I highly recommend NOT doing neutral drops! lol|
|03-02-2006 08:02 PM|
|svtguy88||Hey, not to steal a thread or anything, but how bad is this for the ATX?|
|02-28-2006 10:40 AM|
|jaykirs||Place tranny in neutral, floor the gas pedal, then slap it into gear when the light turns green ...... that is NOT the way you want to launch LOL ..... the method listed above is about as good as your going to be able to do unless you get a stall converter and a trans brake.|
|02-28-2006 10:11 AM|
|eazyrider_tim||And I have Wayne's tune from HIA, worth every penny....running the 93 octane aggressive tune.......shifts like a dream man....I hit 50 in first at wot.|
|02-27-2006 07:22 PM|
|Focus Racer S2||
|02-27-2006 01:22 PM|
|P0WeRbyDuratec||lol its that simple. but something like a sct tune from focussport will adjust your shift points. It is a huge improvement by the way|
|02-27-2006 10:45 AM|
step on the brake........mash the gas to 2500rpm.
step off the brake........put the pedal to the floor and bite your nails.
|02-27-2006 10:06 AM|
|Carrera26||All I know is that you should definitely not do any neutral drops. Perhaps you already knew that, but I always want to mention it.|
|This thread has more than 10 replies. Click here to review the whole thread.|