|Car Audio, SYNC, MyFord Touch & Electronics The Forum for the Ford Focus audiophiles. The place to chat about automobile sound systems, security systems, or show off your I.C.E.!
Sponsored By: GT Sound Control
|Topic Review (Newest First)|
|11-01-2015 09:01 AM|
Keys out of the ignition and press twice. It should only auto-unlock once.
You can also vary the test up and try a few times. With the driver's window open, close all the doors and lock it. Then wait and try. If at any time using any method, if the locks fail to unlock when you press the switch, the GEM has gone to sleep and you'll need to do the tech doc.
|11-01-2015 05:56 AM|
|Cameron.osullivan||If the drivers door is open and I press the lock button it unlocks it's self to prevent locking the key inside the car|
|10-31-2015 10:54 AM|
1. With the driver’s window rolled down, close all the vehicle doors except the driver’s door.
2. With the driver’s door open, lock the door by pressing the driver’s door lock switch.
3. Close the driver’s door.
4. After 3 minutes, reach in through the driver’s window and press the unlock switch in the door. If the doors fail to
unlock you must do Directed tech doc 1093 to wake up the GEM module with your lock and unlock wires.
All the wires you need are in the driver's kick. Bottom bundle of wires. Lock is black/red. Unlock is black/yellow. Unlock detect is black/green. Be aware if you've got a factory alarm, you'll need to use the FAD wire from your Hawk system too. Black/white in the same location, though it's double pulse(-).
Of course, these are for the Focus here in the states. Donno how they are across the pond.
|10-31-2015 07:00 AM|
|Cameron.osullivan||I'm using a hawk system . I do have the gem system I was looking for the lock and unlock wires for the central . I'm not planning on using the remote start yet so wasn't planning on using a bypass module|
|10-30-2015 11:22 PM|
Which system are you putting in and what bypass module are you using?
|10-30-2015 04:32 PM|
|Cameron.osullivan||This is the same as my central locking control module if it helps. Thanks in advance|
|10-30-2015 04:28 PM|
|Cameron.osullivan||I'm am in the middle of trying install a alarm with remote start myself but I can't figure out what wore to connect to in the central locking control module . I have a 2004 1.4 3door zetec focus|
|11-24-2012 04:34 AM|
Hi! Where exactly do I find a "how to" on remote start/alarms?
I have a viper system that I am interested in installing myself
|07-29-2007 02:36 PM|
Help Help Help!!
I am in desperate need of help. when i wired in my alarm i am trying to get the system to unlock itself, the lock feature works a treat but when i try to unlock all i manage to do is unlock the boot release, i know that the door unlock and trunk are both using the same wire (black/Yellow) so i assume i might need a relay or somthing, anyone had this poblem and overcome?? any ideas appreciated, i have tried for days now!!! HELP HELP HELP! firstname.lastname@example.org ford replies direct please thanks in advance
|05-28-2005 08:16 PM|
Captain(brain): Start the car soldier.
Soldier(thumb): Yes, captain. Press the start button.
Car: Cranks and vroom.
Soldier: Car is ready captain.
Captain: Good work, soldier.
I'm just happy. Everything is working! Thanks for the help of everyone especially John.
There is a how to program a key in the owner's manual. It is page 76.
|This thread has more than 10 replies. Click here to review the whole thread.|