|05-21-2014 10:04 AM|
|tgowers||The best way to loosen the adhesive tape is with WD40. Soak it down really good and it should come off much easier.|
|05-21-2014 02:07 AM|
|Sniper Focus||3M tape was all that was holding mine on.|
|05-20-2014 11:08 PM|
I know this is a year old, figured I'd bump it rather than make a new thread.
Re applying them, just 3m double sided auto tape? Or is there a glue I should use.
|06-03-2013 12:50 AM|
|stealthzx3||Mines an '01 and is only held on by the tape, so no clips. Just take a flathead and pry an end out and pull.|
|05-30-2013 02:35 PM|
early cars usually had clips, laters are just stuck on. my 2001 had clips.
You can see the clips if you pull the door panel and look from the inside.
|05-30-2013 10:24 AM|
|nov173||I had 2000 focus which just had tape and small rods that slid through i think 3 holds along the panel. I had no clips. Just used a heat gun and worked my way down with some fine string to cut through the tape.|
|05-30-2013 09:59 AM|
Side Moulding Removal
How do you remove it? Is it just taped on or are there clips too? Searched the whole section and couldn't find it. I need to remove the side moulding to apply wrap and re-install them.