|03-04-2015 10:49 AM|
|GhostTribute||Here is the part number for the '96 Contour Sport L4 2.0 ZETEC; F5RZ8592B|
|03-04-2015 09:41 AM|
Bostig Billet Alum Housing NOW $400.00
Need to replace my original, looked for alternative, $400.00 is to rich for me.
ANYONE have the Conture part number? I read about it being better, but have not seen any picture comparisons, ANY help appreciated since I need to replace mine now, OVER 240,000 miles thus far!
|12-24-2014 02:56 PM|
|jpmoney707||did you ever find a flange for it???|
|08-09-2013 11:04 AM|
Need your help guys, I know this piece is a quality part but I don't need heater hoses and is a bit pricey as it is in $300 plus shipping right now. I only run the hose coming from the rad and the small overflow hose and that is it, thermostat housing craks easily because of the heat of the turbo and one leg of the brace sits in top of it but would like to run the thermostat.
So my question is, anybody knows what flange will fit in the head? I know Mercedes, Chevy, ranger 2.3 and some Jaguars are 3 bolts but what would fit or with a slight modification can fit? Had something in mind simple as this.
|07-31-2013 03:46 PM|
|Hardline||I wonder if they can make one with the bypass hose as an -8AN fitting, and no bleed nipple on the upper radiator hose.... Would work perfect for my turbo project then.|
|07-28-2013 07:10 PM|
|07-28-2013 06:14 PM|
I don't ever trust 2nd or 3rd hand information, so I could care less who you say has burnt up what. If they wish to talk the door's open.
A forced induction kit is far different than a simple water outlet housing. There's virtually no way a chunk of AL this simple is going to melt your engine down.
So your first hand knowledge of the company is what exactly?
|07-28-2013 02:45 PM|
|07-09-2013 09:34 AM|
|jcjc06||Man that looks really nice! When mine goes bad im gonna have to get one of those|
|07-02-2013 10:31 PM|
|qweesy||It will read it just fine but I have a OEM Ford DY1144 3/8 NPT temp sensor (from a older model Contour) And it Ohms out at 27 the stock SVT one Ohms out at 29.5 .......so the dilemma Im in right now is, will the ecu read it as correct, on the gauge and in the ECU? the hookup where the cable plugs in is the same as the SVT but im going around to different part houses and Ohming out different brand Coolant temp sensors and they are all a little different so I think what I have will work just fine just want to be sure before I slap it on though. Im doing the leg work for you guys and Bostig.... Bostig uses a corvette sensor but theirs isnt read through the ECU only the gauge so it doesnt matter but for our fofo's it reads for BOTH so it does matter.|
|This thread has more than 10 replies. Click here to review the whole thread.|