|03-19-2013 01:39 AM|
negative comments aside, as others have said, don't touch them.
I know there's all kinds of numbers but if a cylinder is more than 20% off from any others, there's a problem. that looks pretty good.
|03-19-2013 01:00 AM|
For torque to yield bolts do not retighten them.
If you tightened them according to the bolt pattern and the series of steps required when initially tightening them, leave them be unless you want to remove them and replace them.
Do not 'fix' what is not broken.
Over doing things creates super messed up stuff.
So with your current readings all is fine.
Leave the bolts alone.
|03-18-2013 10:05 PM|
|03-18-2013 09:22 PM|
My Cyl. 1 compression, before the timing belt blew up, were exactly the same as yours. Cyl 1 was in the 175ish mark and the rest were in the 180ish mark. A delta of 15 psi is acceptable.
...the timing belt had nothing to do with my compression. Well it does now while it's at 0 PSI.
|03-18-2013 08:45 PM|
And.. no hard feelings. :D
|03-18-2013 08:41 PM|
|a_2000_se||Ford actually doesn't state a value or minimum for compression readings. Instead they only state that compression measured between cylinders should be within 25%. Unless that's been changed and published somewhere.|
|03-18-2013 08:19 PM|
That is not low compression. 80 is low compression. 3% difference between cylinders is very good.
A blown head gasked also dumps coolant to oil, causes bubbling in the coolant, along with very low compression.
If you torqued the bolts to spec, with oil or whatever lubricant the hardware called for, then it you start to overtighten them the material will start to yeild, resulting in a loss of clamp load.
Sorry to give you the business, it's just that I have NEVER heard anyone ask that question before. I figured anyone that could change their own head gasket would know the answer to this question. Sorry about that.
Go and enjoy your successful gasket change!!
|03-18-2013 08:11 PM|
#2) Low compression can be caused via a blown head gasket.
So now lets step back and think about this, if the head bolts aren't tightened correct you could end up with a warped head.. or just a head that isn't tightened completely, resulting in the head gasket not sealing completely. So while the compression is within specs, I'm wondering about the possibility of tightening the two head bolts to the left of the 1st cylinder. Doing so would further compress the head gasket a bit more. I'm thinking only 1/10th of a turn, but I'd like some input on it.
|03-18-2013 07:33 PM|
Please tell me this is a joke.
You are not serious are you?
If you are serious, you need to put any tools you have down immediately and step back from the car. Please call a professional.
The head bolts have nothing to do with your compression. Compression is a function of valve timing, ring wear and swept to clearance volume.
Your compression is fine.
|03-18-2013 06:24 PM|
Head Bolts - Tighten a bit more?
I recently replace the head on my SPI motor.. New gasket, bolts and all that good stuff. I ran it for 1k miles and tested the compression..
Cyl 1: 175
Cyl 2: 180
Cyl 3: 182
Cyl 4: 180
Should/Can I attempt to tighten those first two bolts by the 1st cylinder just a tad bit? Or should I just be happy it's within 3% of the others?
Or.. should I first throw a tad bit of oil into that cylinder to make sure the rings are just wearing out?