Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - Reply to Topic
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum > Ford Focus Tech Discussions > General Technical Chat > Cleaning the EGR tube

General Technical Chat This section is for technical discussions relating to general maintenance, electrical issues, engine trouble, and recalls.

Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Thread: Cleaning the EGR tube Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-12-2013 08:57 AM
Andrews-bad-SE I'll spray some soapy water on them and see if any bubbles happen
03-12-2013 07:12 AM
amc49 The hoses to DPFE are pressure not vacuum, you can look for a vacuum leak there forever..............
03-10-2013 11:42 PM
Andrews-bad-SE I'll look into the DPFE sensor then. That seems to be a tricky little bugger. Thanks for the help!
03-10-2013 10:33 PM
don627 Check for VAC leaks especially the one that attach to the dpfe sensor.
03-10-2013 10:11 PM
amc49 With automatic mixture control EGR parts stay quite a bit cleaner than they used to. I remember the days when you could cake up half inch diameter pipes solid as a rock with carbon.

Probably DPFE sensor, especially if the very short stub hosed one. I had to make up a workaround on mine when water kept getting into sensor to fault it.
03-06-2013 11:12 AM
Magus2727 You have replaced the DPFE with a Ford one? Aftermarket ones are not so great at this... Have you replaced the EGR valve or just try to "clean" it?

P0401 - EGR Flow Insufficient Detected
The EGR system is monitored during steady state driving conditions while the EGR is commanded on. The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum.
Vacuum supply
EGR valve stuck closed
EGR valve leaks vacuum
EGR flow path restricted
EGRVR circuit shorted to PWR
VREF open to D.P.F. EGR sensor
D.P.F. EGR sensor downstream hose off or plugged
EGRVR circuit open to PCM
VPWR open to EGRVR solenoid
D.P.F. EGR sensor hoses both off
D.P.F. EGR sensor hoses reversed
Damaged EGR orifice tube
Damaged EGRVR solenoid
Damaged PCM
Perform KOER self-test and look for DTC P1408 as an indication of a hard fault. If P1408 is not present, look for contamination, restrictions, leaks, and intermittents.



Define "Crap" If you have crap that go in there then you have larger issues then just EGR codes. The EGR is a quasi closed system. It only routes a small portion of pre CAT exhaust into the intake after the TB. Any "Crap" would also be coating your catalytic converter and plugging the honeycomb or building up over time a thicker and thicker layer on the exhaust manifold.
03-06-2013 09:22 AM
Andrews-bad-SE Mine's just throwing the P0401 still and I've cleaned/replaced everything... but I forgot to clean the tube that goes into the intake from the valve (Zetec 2.0 engine btw). I'm just afraid that I might accidentally push some crap into the intake and the engine would suck it all up.
03-06-2013 01:27 AM
amc49 Absolutely worthless to clean it until clogged enough the passage gets smaller than the restriction hole in there...................
03-05-2013 04:19 PM
Magus2727 no real reason to worry about it. It is not a "dirty" part. You would not crack open your exhaust system to clean them out. I would only clean it if you had it out or replacing it for some other reason.
03-05-2013 02:58 PM
zpellicone Im curious if I should do this. What is the outcome when you do this? Smoother idle, better gas mileage?
This thread has more than 10 replies. Click here to review the whole thread.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 04:37 AM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Audi S3, Ford Fusion and Acura TLX. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area. Challenger Hellcat - Charger Hellcat