Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - Reply to Topic
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum > Ford Focus Tech Discussions > General Technical Chat > Fan blower making noise~~

General Technical Chat This section is for technical discussions relating to general maintenance, electrical issues, engine trouble, and recalls.

Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Thread: Fan blower making noise~~ Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-24-2014 02:30 PM
pfsantos On my 2009, the three screws to remove the fan were accessible. Nothing else to remove beforehand.

But to get to the bottom bearing, I had a bit of a hard time removing the bottom cover, which has wires attached to the plug, which is part of the bottom cover. So it's easier to drill a hole in the middle of the round part on the cover, lube the bearing, then cover with black electrical tape.
11-25-2013 10:44 AM
Todd GT5
Fixed fan noise!!

Hello all,
Thanks to this thread, I have successfully fixed my fan noise.

Thanks
-Todd
04-09-2013 09:33 PM
Oblivion
Quote:
Originally Posted by iB Chunkyboy View Post
Pics don't work :[ help please
Hello, iB Chunkyboy.

If 'pics don't work': How about a video instead?

Here. I made this just now specifically because I saw your post.
This is for the 2001 Ford Focus ZX3 model though. I'm unsure if the 2000 version is any different.

Video link: http://www.youtube.com/watch?v=0XM7okhkpXg
YouTube Video
ERROR: If you can see this, then YouTube is down or you don't have Flash installed.


Hope that helps you out. Sorry for the poor lightning quality. It went pitch black out here.
Now I have to reinstall it without seeing too much!
01-31-2013 05:17 PM
Joelnaf Very common for it to do this at low speeds or when breaking turning etc.... just remove the fan like shown above then blow it out with a compressor. Oil up the two copper bearings top and bottom of the fan shaft. Sound will go away.
01-31-2013 04:31 PM
josephd My fan does the same thing. It does it when in motion, and sitting still. When it gets cold, the low speed(#1)makes noise. If I put it on the second speed it goes away.
01-31-2013 03:27 PM
Aaron1331 mine does this buy only when braking and on fan speed 2 and 1
01-28-2013 03:09 AM
grand106 Much appreciated, because I thought I might be doing something wrong (it felt too difficult to be the correct way)
p.s If I dive upside down I then have to repair passenger’s seat afterwards . then to another thread and the story goes on

thanks again , i will try it again soon
01-28-2013 12:22 AM
sailor I reached up from underneath, primarily by "feel" 'cause I didn't feel like diving upside down under the dash if I didn't have to!

Used a torx bit in a 1/4" socket at the end of a 6" extension (1/4" drive). Handle to break loose, fingers on extension to run in & out.....

Worked fairly easily that way. Do the back one first (hardest to get at), since the others will hold the fan in place while you get the hard one out. put it in last on re-assembly....

Luck!
01-27-2013 05:27 PM
grand106 i just want to ask one thing? How on earth did you all manage to squeeze your hand to remove those 3 screws (torx type they are, at least in my focus ii (late 2008 model)


I try using a flexible extension fitted with a torx end with an electric screwdriver but yet again I can’t even see the 2 out of 3 screws yet alone to even consider removing them . (I feel that if I try that –in blind- by feeling with the edge of my fingers most probably the screws should be lost inside the engine’s abyss). i also have Haynes manual to help me but …

01-04-2013 01:25 AM
silver9 i just wanted to say thanks to gondorian Tri-Flon is awesome. I use this stuff on everything!!!
This thread has more than 10 replies. Click here to review the whole thread.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 07:19 AM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Audi S3, Ford Fusion and Acura TLX. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area. Challenger Hellcat - Charger Hellcat