|01-27-2013 08:18 PM|
|01-27-2013 08:04 PM|
|RAF_S197||So if I were to swap the widow button panel out I a Ti one would it work in my SE?|
|01-27-2013 04:56 PM|
I have the four one touch auto up and down window controls on my car.
|01-27-2013 04:43 PM|
|01-27-2013 04:37 PM|
|RAF_S197||I'm surprised the 2012/2013 focus doesn't come with one touch up windows. Wish they did|
|01-27-2013 01:16 AM|
A couple of days ago I noticed that the drivers window on my car had stopped doing the one touch thing.
Not sure how it happened because I didn't disconnect anything.
The only thing I can think of is that I accidentally tripped a button combination that will disable it.
I was about to start digging through the manual to try to figure it out.
But decided that while I was on line I might as well look around here to see if anyone else had a similar problem.
Not seeing anything right away I used the search function and found this thread.
I just tried the reset routine and Ta-Da it now works fine.
So thanks again.
|06-19-2012 09:29 PM|
Okay, I've sorted it.
1. Hold button down until window is all the way down
2. Release for a split second
3. Hold button down for 5 seconds
4. Hold button up until window is all the way up
5. Release for a split second
6. Hold button up for 5 seconds
I wasn't doing steps 2 and 5.
|06-19-2012 06:11 PM|
I believe my dealer disconnected the battery and now I am having this problem.
Was able to reset the 2 back windows (hold open for 5 seconds, hold closed for 5 seconds) and now they are both working one touch.
However, I seem to be unable to do the same with the front 2 windows. Holding 5 seconds open, closed, open, etc.
Any ideas? Thanks.
|05-06-2012 06:49 PM|
|05-06-2012 04:22 PM|
|This thread has more than 10 replies. Click here to review the whole thread.|