|01-21-2013 11:02 PM|
|goinloco1||May want to go to the parts store and grab a can of maf cleaner. May take care of some of the other problems or at least smooth them out some. no telling how long its been since its been cleaned last.|
|01-21-2013 10:59 PM|
my bad, missed that post...lol
got to reading everything else and musta skimmed it.
|01-21-2013 10:47 PM|
|SanduskySerpents||The erratic readings came from th OL fault and bad wiring. But it's fixed now. The car only has what I would call the usual stumble. It's not perfect but it runs|
|01-21-2013 10:41 PM|
The downstream o2 does nothing but monitor the cat. If your getting wierd readings on it and your upstream your cat may be shot. your saying it runs like crap and isn't drivable also leads me this way.
By the way, stay away from bosch sensors, they are either crap right from the factory or burn up shortly. Definitely stay away from the bosch universals where you have to splice wires.
As was said, stick with oem.
|01-21-2013 09:56 PM|
|SanduskySerpents||Yeah I didn't solder them but I did use heat shrink over the connectors to weather proof.|
|01-21-2013 09:49 PM|
Well I had that in there somewhere and redid my post since it wandered too much.
Point was, O2 sensor circuits are low voltage, when cut they need best connection possible, I've cut them before, preferable to solder them to prevent later humid conditions messing up the connection by corrosion, it doesn't have to be visible corrosion to cause trouble there.
|01-21-2013 09:38 PM|
|SanduskySerpents||When I rewired the o2 sensors they started functioning again. In all this mess I think I have solved it. Idle was ruff sounding like an overly aggressive camshaft were in it always about to die. I performed a smoke test after rewireing failed to fix everything and I found a that the EGR gasket failed catastrophically . After this I pressurized the cooling system a found 3 hoses leaking. Replaced gasket and hoses and it started idling 90% better. The unmetered air was causing it to go into open loop fault which just exasperated the problem.|
|01-21-2013 09:08 PM|
Did you ever check the o2 fuses ? You wouldnt have a bad ECU for these issues and it doesnt surprise me your not getting any codes for this , check the o2 fuses
|01-21-2013 09:04 PM|
|SanduskySerpents||I know it's not a series circuit, just a a turn of phrase. I think I have it solved not sure yet. Update in a few|
|01-21-2013 08:54 PM|
Just trying to help...
The fact that the car isn't setting any codes and running so poorly gives me the gut feeling that something is wrong with the ECU or one of the power or ground feeds to it. The ECU will have several powers and grounds, not just one. It is not in a series circuit.
|This thread has more than 10 replies. Click here to review the whole thread.|