|12-14-2014 11:29 AM|
|Rsaxon||are the connectors on the st leather seats same as ford focus zetec s 2012|
|03-10-2014 10:04 AM|
|bproctor||Ok I feel stupid, I used one of the add a fuse adapters and didnt realize that I had to put two fuses in it for it to work. I still dont understand why i didn't get a reading on the multimeter though.|
|03-10-2014 08:59 AM|
|bproctor||I just installed heated seats yesterday and everything seemed to go well. I seem to be having a problem with the luggage compartment fuse panel. When the seats didnt power on I went back to double check the fuses and they were good. I then put a multimeter on the fuse panel and never could get a reading. Anyone have any ideas?|
|02-12-2014 10:13 PM|
Btw, here's the other end of the seat connectors they show in the other post. And the factory heat pad.
So factory heat pad is using two connectors, one green and one blue.
It would be nice to see how someone that has factory installed heated seats' connectors line up...
|02-12-2014 09:49 PM|
Interesting. I'll have to look into the BCM, and your right, worst case, use aftermarket in place of factory switches.
So the thread you linked has a picture specifying the pins for the heated seats (for the ST). I'm not sure how he confirmed that, as in our manual, it says fuse 85 is heated seats, as well as the "passenger airbag deactivation indicator" (PADI), and some other things. I don't want to screw up the occupancy detection sensor.
And that electrical connector their showing is the one under the seat, not under the cupholder... I wonder does the power run from the fuse panel to the switches, and then to the seat connectors and pads? Or does it go from the fuse to the seat connectors and pads, with a separate wire back to the switch.?
|02-12-2014 05:54 PM|
Let us know how it goes though, I have that factory switch piece as well and was going to dive into it this summer. If all else fails you could dremel out the factory switches to mount the aftermarket ones and it would look "almost" factory.
EDIT: This whole thread might be of interest to you, it's from another forum. But I'll link to one post. Someone with an ST verified that the wiring under the seat is there, and hot. Not sure if it's the same case with a S or SE.
|02-12-2014 01:30 PM|
By the way, here's a pic of the new cup holder/seat heater switches... Looks like a couple of 4 pin connectors.
Rockauto has the connectors, and I am guessing these would work... http://www.rockauto.com/catalog/x,ca...%2B2012%2BFORD
But if anyone can confirm before I buy them..? And would they run from the switches all the way to the passenger compartment fuse panel, specifically fuse 85?
I've never done any automotive wiring before; learning as I go.
|02-11-2014 08:01 PM|
Hey guys, this definitely seems to be the go to thread for heated seats on the '12 focus.
I'm trying to do an oem install, so I pried up the existing cup holder hoping to find some extra connectors, but no luck. Just one wire for the 12 volt outlet.
Anyone know if there are wires here to tap into? Will I need to buy the leads for the new switches?
|02-09-2014 08:49 PM|
|02-09-2014 07:34 PM|
Fuses F34 and F35
|This thread has more than 10 replies. Click here to review the whole thread.|