|03-16-2013 07:41 PM|
|03-16-2013 05:29 PM|
To block off EGR and pass emissions... that might be best to start a new thread. This one is talking about how to add it to the SVT header.
To pass emissions with out it. You need a tune, will cost you some $300+
You will also need a block off plate and leave stuff in and or attached or parts removed so if engine bay inspection is done they wont see it not connected.
It will be easier to take it to a shop have them weld in a bung.... but choice is yours.
|03-16-2013 03:24 PM|
|Trev FF||ok. so i have a 2000 zx3 and i recently got svt header, cat, and flex. what do i need to do to block off egr and pass emmissions?|
|03-05-2013 01:01 AM|
Didnt realize this thread got so much use so far.
Just to update what is going on here, specially for the other IL guy....
So far I've gotten an old egr bung off another focus(thx karl) and got at a shop to weld it on to an old svt header, the egr tube is screwed on & all sealed up, I've got a brand new EGR Valve at the other end of the tube and tightened that down, and i've attached a new dpfe sensor to the hoses on the egr tube.
Only problem is, the car starts screwing up and misfiring if i attach the vacuum line to the top of the egr valve, unplug the hose & the car runs fine.
Both parts are brand new, on the car for no more than 2 weeks at most(egr valve not even 12 hours currently). I am at a complete loss where to look for the issue now.
|02-25-2013 05:05 PM|
|Sniperx||I FRIGGIN hate SMOG! If I lived 3 miles East of where I DO, I would not have to have it smogged.|
|02-14-2013 09:48 AM|
the problem is that most shops have no idea how to weld it up. I have gone though 3 different exhaust shops with 2 different headers (because 1 got messed up in a large way). Even had one go as far as putting a right angle tube steel in welded that, cut off the flair and nut on the EGR tube and said some "high temp" silicon would work to "bridge the gap".... that fell apart before I got home.
That is why I did a mock up, found a fitting, cut the hole my self, welded it in and then cleaned up internal to the runner on my own. I did need to bend the EGR tube slightly, but their is still plenty of airflow through the tube.
I also plan on tapping my self and making my own EGR Cap that goes on the header bung. so I can get rid of the EGR system but be able to install it when I need it.;-)
|02-14-2013 08:43 AM|
|homelessmonkey||or buy extension 02 sensor cables so it reaches stock position|
|02-13-2013 09:27 AM|
|homelessmonkey||just go to a shop and get it welded in|
|01-23-2013 09:49 PM|
|71shadow||i have a svt header with no egr tube got the egr block off from jayracing and tom tune fixed all fuel issues and the power is awesome|
|01-23-2013 06:55 PM|
|This thread has more than 10 replies. Click here to review the whole thread.|