|12-25-2014 04:05 PM|
|cgk60||Dropped at 138,000|
|03-24-2014 09:44 PM|
143K. I just swapped a new head on, due to a valve seat loose enough to keep the valve from closing part of the time. Had a shiny mark around the edge of the valve relief in the piston, where the valve/seat was making slight contact, and the seat is visibly cracked at the point it is closest to the exhaust valve.
No, it didn't drop a seat, but it was about to do so.
I purchased a new head casting from J&C Enterprises, ( http://www.ebay.com/itm/350998600428...84.m1423.l2649 ) extremely pleased with it. Highly recommended.
|03-11-2014 11:14 PM|
I replaced the head with one from headsonly.com at about 110k miles as preventative maintance. It cost ~$1000 altogether since I replaced quite a few other things while I was at it, but well worth it in the end. I especially like the fact that I no longer worry about when the valve seat will drop!
It's been running for 15k miles or so now. :)
|03-08-2014 06:46 PM|
|Dmperfection||My '02 dropped #4 intake at 170k miles. Yes, I was a skeptic and believed that only those engines that weren't well taken care of were susceptible. I always ran clean synthetic oil, cooling system flush every year and kept up with t-stat replacements. I was wrong. Ironically, three months ago, I seriously considered pulling out the head in a preventative effort. I was skeptical and decided against it. One week ago, it happened to me. Now I'm tearing it apart.|
|02-18-2014 04:28 PM|
|Martyman||2001 SPI with 118000 and cyl 4 dropped 2 weeks ago.|
|02-18-2014 03:34 PM|
|cameron 55||2 valves dropped around 99,000 miles so I rebuilt the cylinder head|
|10-03-2013 01:43 PM|
|Texas Ranger||114xxx and no dropped valve seat, though I have heard a lot about em'|
|08-26-2013 01:21 AM|
|08-25-2013 02:07 PM|
|Pegasus8891||Dropped at 117k|
|07-30-2013 01:32 PM|
|fordmaster302||Mine is currently at 245,000 miles engine is still all original|
|This thread has more than 10 replies. Click here to review the whole thread.|