Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - Reply to Topic
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum > Ford Focus Tech Discussions > General Technical Chat > Bad clutch master cylinder? Or slave cylinder?

General Technical Chat This section is for technical discussions relating to general maintenance, electrical issues, engine trouble, and recalls.

Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Thread: Bad clutch master cylinder? Or slave cylinder? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-07-2013 10:44 AM
DerbyDave I was able to get my master cylinder cheaper at Orielly's when I factored in shipping costs. Normally though I buy stuff through RockAuto.

Bleeding the master cylinder can be a pain. See my write up on the pressure method I used.
http://www.focusfanatics.com/forum/showthread.php?t=305412
01-07-2013 12:14 AM
F O C U S I ordered my clutch master cylinder from Advance I got it the next day in the morning and by the afternoon it was installed. No more wet pedal :)
01-06-2013 10:02 PM
CharlieO I recently did this and me only beeing 17 its a pretty easy instal just have fun bleeding the clutch that was the most difficult part if anyone can help explain it please do if not ill try my best in a little bit
01-06-2013 04:48 AM
sleepyboy Thanks, and I hope it goes easy for you. I removed my drivers seat when I did mine so I could have some room to work and lay on the floor.
01-06-2013 04:47 AM
Jack The Ripper
Quote:
Originally Posted by sleepyboy View Post
HERE is the how to on replacing it.
Thanks man. +Rep for your opinion and the helpful link.
01-06-2013 04:33 AM
sleepyboy HERE is the how to on replacing it.
01-06-2013 04:32 AM
sleepyboy It could if you lost enough fluid, but I think they have a divider wall in them but I'm not 100% on that.
01-06-2013 04:21 AM
Jack The Ripper
Quote:
Originally Posted by sleepyboy View Post
Your on the right track, if your pedal is wet it's from the brake fluid leaking onto it.
Awesome, so it definitely sounds like the CMC and not the slave then, right? Would the loss in brake fluid also cause my brake pedal to go soft like the clutch pedal? I feel like it would since they share the same reservoir..
01-06-2013 04:11 AM
sleepyboy Your on the right track, if your pedal is wet it's from the brake fluid leaking onto it.
01-06-2013 04:01 AM
Jack The Ripper
Bad clutch master cylinder? Or slave cylinder?

Hey guys,

Lately I've been barely driving my car. It's been sitting in the driveway a lot over the past three months. About a week ago my clutch pedal started feeling very slippery, almost as if I had rain water on the bottom of my shoes from wet weather. The clutch pedal feels soft when pushed in, and my brake pedal definitely feels softer too (that might be because I asked the shop to top off the brake fluid reservoir when I got two new tires since I knew my brake fluid was low because of the leak.)

I can still upshift/downshift perfectly fine. My transmission has no problem engaging gears, and the clutch is definitely not slipping. I looked under my car at the bellhousing, there isn't any signs of a leak. The pedal only starts to feel wet after driving around for 10mins after it's warmed up, and there's never a puddle of brake fluid on the carpet. I think I've narrowed it down to the clutch master cylinder going bad, but I just wanted everyone's thoughts/opinions. Does it sound like the CMC, or a slave cylinder? Does anyone know by chanced what the procedure for replacing a CMC is? I.E. How long does the whole job take?

I think I'm going to order this CMC from RockAuto on Tuesday.. let me know what you think about it.


Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 09:49 PM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Audi S3, Ford Fusion and Acura TLX. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area. Challenger Hellcat - Charger Hellcat