Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - Reply to Topic
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum > Ford Focus Tech Discussions > Wheels & Tires - Sponsored By Tire Rack > How To: Reset TPMS with no learning tool

Wheels & Tires - Sponsored By Tire Rack The place to go for answers on wheel types, tire sizes, offset, wheel patterns and more.
Sponsored By:
Tire Rack


Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Thread: How To: Reset TPMS with no learning tool Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-21-2014 06:29 PM
2012FocusSESport Just installed 4 new Conti Extreme Winter Contact tires on new steel wheels with new Ford TPMS sensors. Low tire light came on 52 miles later. Using the TPMS-19 TPMS tool and having the car in the learning mode did not work to train the system. Trying the other way by letting air out did not work either. I ended up at the Ford dealer and they put the car in train mode used a bigger TPMS tool, and voila each tire sensor checked in ok. The technician then took my TPMS-19 trigger tool and I put the car in training mode and it worked this time. The mx tech said they are seeing some of the new TPMS sensors that need to be initialized the first time with the tool he used then they work fine with the little TPMS-19 trigger we bought. $30 and 30 minutes from driving in to leaving. I tried 3 times before going to the dealer, but nothing worked. Hope this sets it up for the remainder of the times we'll be swapping tires in spring and winter.
11-20-2014 04:21 PM
ehlersgrub I have a 2012 Focus. I was able to get in the program mode quite easily but could not get the first step (LF tire) completed. I made sure all the tires were at the correct pressure (35 psi) before I started. I bled the tire almost flat with no results. I did this seveal times included running the car around the block to hopefully activate the sensors.
11-20-2014 04:16 PM
ehlersgrub
Quote:
Originally Posted by JMD787 View Post
Hey guys and girls. I came across a way to train new TPMS sensors. Use this if you're installing winter wheels/tires that have sensors already installed, or even if you are just doing a tire rotation. Not sure if this has been posted before. I tried searching but didn't see it posted anywhere. No need to go and buy the TPMS learning tool.

1) Make sure your tires are inflated to the recommended psi. Mine is 40psi.

2) Turn ignition to the on position. If you have a push button start, push the start button without pressing the brake pedal.

3) Push the hazard light button 6 times. The horn should honk and you should see "Train left front tire" in the LCD display between the tach and speedo.

4) Release air pressure in the front left tire until you hear the horn honk. The LCD display should now read "Train right front tire".

5) Release air pressure in the right front tire until you hear the horn honk.

6) Repeat for the the right rear tire, and then the left rear tire.

7) You should now see "Training Complete" in the LCD display.

8) Fill your tires back up to the recommended pressure.

Enjoy!
I have a 2012 Focus. I was able to get in the program mode quite easily but could not get the first step (LF tire) completed. I made sure all the tires were at the correct pressure (35 psi) before I started. I bled the tire almost flat with no results. I did this seveal times included running the car around the block to hopefully activate the sensors.
11-17-2014 04:05 PM
Tabor I just installed snow rims/tires from TireRack. I was unable to train my aftermarket (TireRack) TPMS sensors with this method. I was however able to use a the Motorcraft TPMS19 which I got off of Amazon for $36. This is for a North American 2014 Focus SE.
11-15-2014 09:07 AM
Juicedz I have to swap mine over to the new rims. I'm may just leave them on the new wheels and get normal valve stems installed on the old ones. However, if I decide to sell them I feel like this sort've screws over the buyer in more way than one. Might just throw the eBay tpms sensors in the old wheels. Is there a specific ebay set that has been proven to work 100%?
11-14-2014 06:41 PM
29Tudor Can't get this to work. I can get it to say "train left front" but let almost all of the air out and nothing. I tried this 4 times. I got my sensors from the same place as Satchmo_Pops, wonder if they aren't the right ones?
11-12-2014 12:31 PM
Satchmo_Pops Is there a risk in doing this with already "learned" sensors? I'm planning on buying Motegi MR116 17" rims and buying sensors from either titan TPMS online or ebay. My hopes are that I can verify that the process works and then repeat it with the new sensors on new rims. Any risks here?
11-04-2014 08:22 PM
mazlovski I bought these sensors on ebay and had them installed on my steel rims

http://www.ebay.com/itm/4X-Tire-Pres...6da995&vxp=mtr

When I tried resetting the sensors it wouldn't work. I started with front left tire and went from 36 psi to less than 10 (40 to less than 10 in 2nd attempt) and each time it failed. Are the sensor "location specific" meaning each sensor has to be installed in a particular spot, or it does not matter which one goes where?
06-03-2014 02:05 PM
fixyasometea Hello thought I'd let you guys know titantpms.com carries pretty much every make and model tpms. I have all the relearns. I'm a agent for them email me with any questions! Andrewtitantpms@gmail.com.
05-16-2014 07:03 PM
5speedRuby i find i dont believe this, not so the procedure but i have had 3 sets of wheels and 3 different sets of TPMS sensors of off 3 different types of cars and never once has my focus needed a relearn. i had factory 16" wheels with ford tpms. than switched to 18" aftermarkets with TPMS sensors from an ST. and currently have 19" 2014 ford fusion wheels with the factory fusion TPMS sensors installed and as soon as i switched my wheels all three times the focus automatically relearns itself like its supposed to. never once had a tire light on due to needing a relearn procedure
This thread has more than 10 replies. Click here to review the whole thread.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 09:46 PM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Audi S3, Ford Fusion and Acura TLX. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area. Challenger Hellcat - Charger Hellcat