|12-06-2012 09:44 PM|
|02-13-2012 01:11 PM|
|Stangbanger242||If you have a new sensor, run an abs capable scanner through the obd2 port. Should tell you which corner is the culprit. Swap the sensor and check it again.|
|02-12-2012 11:07 AM|
ebay for $60 used.
|02-12-2012 10:26 AM|
|blkhwk11||I have the same issue but have been told its the abs module,anyone know where i can pick one of these up cheap???lmk|
|12-22-2011 08:28 PM|
Odd, not sure how the tone ring would get damaged with a front brake job lol.
Also when I did my rears I bent the rings a bit and banged them back as straight as possible but still visibly not perfect and I don't have any codes....
Atleast it's fixed for yoou now anyway.
|12-22-2011 05:28 PM|
|Laminar||Turns out the brake job was a red herring. I took it into the dealer today and they pulled the code for me - RR wheel speed problem. They took off the wheel and drum and found the tone ring was damaged. I paid for the diagnosis ($89) and the tone ring only ($46), they didn't charge me any labor or time. Very pleased to have this working again, just in time for snowy weather.|
|11-05-2011 08:50 PM|
|don627||The issue may not have anything to do with the brake job. Need to find out what the codes are in the ABS module to really diagnose anything. Could be as simple as a broken wire in the wheel sensor wiring harness, if the sensors are working you need to verify that the signal is coming out the other end of the wire.|
|11-05-2011 08:35 PM|
It should be sending a signal to the elm to know what each wheel speed is that's how abs and tv work if it reads fronts are alot fast then rear it apples the brakes to allow better traction did you check the rear sensors
Posted via FF Mobile
|11-04-2011 09:09 PM|
|Laminar||What do you mean by "it should be sending out a signal"? I confirmed that the AC voltage reading of both front wheel speed sensors changed with tire speed. What else can I do?|
|11-04-2011 07:46 PM|
|focusZX505||IIRC you can't really check the air gap on these sensors. it's built into the wheels bearsing and spindle. also it should be sending out a signal|
|This thread has more than 10 replies. Click here to review the whole thread.|