|12-03-2012 04:22 PM|
|8.5Racing||Ok im gonna take it apart again see where i went wrong ill let you know thanx for help|
|12-03-2012 03:04 PM|
So long as the valves are shut, yes.
A 4cylinder is 180* opposed. If 1/3 is at TDC then 2/4 have to be at BDC.
|12-03-2012 02:45 PM|
|8.5Racing||Btw thanx for yas help|
|12-03-2012 02:28 PM|
|12-03-2012 02:25 PM|
|8.5Racing||I dont see it bein iac because it was jus runnin fine till i did the timin belt|
|12-03-2012 06:31 AM|
Well, for one, you're not in the right section- I can help with that. Moved to General Technical Chat.
So, the car starts, then dies? Did you disconnect the IAC at all? Have you removed the IAC to clean it and make sure it's plunger can move- it's not caked up with black oily crud?
|12-03-2012 01:21 AM|
Cam timing is off.
Don't use a screwdriver.
Use air pressure to force #2/4 to BDC. You'll have to move the cams to close the valves but it works better than anything else I've found to find true TDC #1.
|12-03-2012 12:22 AM|
|12-02-2012 08:37 PM|
I got a 2000 focus dohc i goto replace timin belt i use flat bar on camshafts and i dont have the pin that goes in back block so i get #1 up to tdc lettin the piston push screw driver up an the keyway on crank is straight up put it together check make sure nothin is hittin by turnin it over by hand goto start it and car runs but have to give it gas it will not idle.....what did i do wrong?