|11-21-2012 07:19 PM|
|CopperMach||Glad to help.|
|11-21-2012 04:28 PM|
|11-21-2012 11:54 AM|
Just looked this up on the parts computer at work.
The dogbone has superseded from 5s4z-6068-ba to 5s4z-6068-bc.
The mount has superseded from 5sz4-6e042-a to 8s4z-6e042-b (or 8s4z-6e042-a if trans is an auto)
The bolt is a w702801-s439.
The new mount should work with the old dogbone, but i stress "should." Hope that helps.
|11-20-2012 03:08 PM|
|Marbs||So the lower mount comes with the bracket? I guess I'll have to take a trip to a stealership.|
|11-20-2012 12:36 PM|
|whynotthinkwhynot||Purchase a new motor mount from a Ford dealer and you'll get a new bracket with it. If you have a poly mount, then you can simply use the new bracket. IIRC, the cost is like $75, maybe a little more. Only the Motocraft part will come with the bracket. You should be able to look all this up on the computer at the parts counter.|
|11-20-2012 11:49 AM|
Need help fast.
So few years ago I replaced the lower engine mount bushings for the poly ones. When putting it back in my buddy stripped it out a bit. We taped it and it seemed fine. Well here it is a few years later and the bolt wobbles loose and I have to tap it back in with a hammer. I tried to JB-Weld it to keep it from coming back out, but that band-aid isn't working. So I guess it's time to order the part. I put the part number into Fordparts.com and it says it can't find the part. I am going on a road trip next month and in order to take my car I'm gonna need this fixed(The Focus gets better gas mileage than the Jeep). Can someone tell me if the part number has been updated, or what my options are? Can I use a heli-coil? Should I load up in inside of the bolt with JB-Weld? Any help and advice is GREATLY appreciated.
This is the bolt. (you can see the JB-Weld not working.
Here's the part number.
I'd head into a dealership and ask, but that's a 25minute drive out of my way, and you guys are here and just as knowledgeable if not more knowledgeable.