Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - Reply to Topic
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum > Ford Focus Tech Discussions > Engine & Transmission Swap > 06 2.0 into 04 2.3 engine swap?

Engine & Transmission Swap The place to chat about any engine and transmission swap.

Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Thread: 06 2.0 into 04 2.3 engine swap? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-22-2012 11:34 PM
felixthecat
Quote:
Originally Posted by timbowabo View Post
Good info felixthecat. Thank you.

I'm going to move forward with the job.

The two cars are not currently available for a side by side comparison.

What would happen if I did a straight swap without changing the head as suggested?

Would it be easier/cheaper to switch the pcm out rather than putting the 2.3 manifold on the 2.0? I have the entire 2006 2.0 at my disposal. The damage didn't affect the engine at all.
You could try it right now by switching the pcm's & seeing if they run. I don't think its going to work w/ the imtv that the 23 has. I know you'll have your car down, but to speed it up, pull the 23 out & remove the head, clean it up for the 20 motor w/ intake manifold.
11-22-2012 11:17 PM
timbowabo Good info felixthecat. Thank you.

I'm going to move forward with the job.

The two cars are not currently available for a side by side comparison.

What would happen if I did a straight swap without changing the head as suggested?

Would it be easier/cheaper to switch the pcm out rather than putting the 2.3 manifold on the 2.0? I have the entire 2006 2.0 at my disposal. The damage didn't affect the engine at all.
11-19-2012 07:34 PM
felixthecat
Quote:
Originally Posted by timbowabo View Post
Good to hear streetfocus. Thanks.

I'm being told wiring is going to be a problem.

Anyone know for sure what I can expect?
You will found the 23 has imtv, unlike the 20. Both use the imrc thou. I'd figure out if you can use the 23 head (after doing a valve job) on the 20, w/ the 23 intake manifold, then you shouldn't have any issues, w/ the pcm. You'll see the 2 electronic vacum switchs on the 23 & only 1 on the 20.
11-18-2012 10:46 PM
timbowabo Good to hear streetfocus. Thanks.

I'm being told wiring is going to be a problem.

Anyone know for sure what I can expect?
11-16-2012 09:59 AM
streetfocus I think it will be fine. I hear that going the other way, 2.0 to 2.3, you have to shim the motor mount about a half inch. I don't know how that will affect you doing the reverse.
11-16-2012 09:21 AM
timbowabo
06 2.0 into 04 2.3 engine swap?

Hello Fanatics!

I have a 2004 Ford Focus wagon with a 2.3 engine. She has 321,000 hard miles and is showing signs that the end may be near. (Timing chain rattling, losing power, not shifting well, etc.)

I have a wrecked 2006 Focus wagon with a 2.0. Everyone I speak with about it is rather pessimistic about the engine/transmission swap, but I feel like they are just making uneducated guesses.

Does anyone here know what type of problems might arise if I attempt it? Wiring issues, computer compatibility, mounting, etc.?

I read on another thread that the reverse (2.3 in, 2.0 out) could be done easily because the only difference was "displacement is a little bigger".

http://www.focusfanatics.com/forum/s...=282199&page=2

Saving my beloved 04, while getting this junk 06 out of my back yard would be great. What do ya think?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 02:03 PM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Audi S3, Ford Fusion and Acura TLX. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area. Challenger Hellcat - Charger Hellcat