Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - Reply to Topic
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace

Go Back   Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum > Ford Focus SVT > SVT Performance (2002-2004) > Why would a Slave cylinder keep going bad?

SVT Performance (2002-2004) The place to chat about any 2.0L SVT DOHC Zetec engine performance, tuning and exhaust related upgrades.

Search This Forum | Image Search | Advanced Search    
FocusFanatics Merchandise

Thread: Why would a Slave cylinder keep going bad? Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-15-2012 01:26 AM
sleepyboy Welcome to the Forum

If 3 in a row are going bad then I would start looking at the other clutch parts such as the pressure plate and clutch. Also check out the Master Cylinder at the pedal for leaks or anything of that nature. Also are you sure your using the correct part for the SVT? The MTX-75 slave cylinder can also fit the getrag but the hole for the shaft is too big. They look identical to each other only difference the hole diameter. If you put one on a SVT it will leak fluid, I know cause...
11-15-2012 01:20 AM
fakitol Just an info, when I put brand new master cyl my slave went bad after awhile. GL
11-14-2012 11:34 PM
Mike_Mac our cars don't have a clutch fork.

did the same thing fail on them each time?

could only imagine dropping the trans 3 times in 2 months.

if its the same pressure plate some of the fingers may be damaged causing uneven pressure on the throwout bearing and slave cylinder
11-14-2012 11:00 PM
Ford Fanatic i bet all your slave cylinders are fine.. even the stock one. check your clutch fork :)

good luck!
11-14-2012 10:36 PM
Why would a Slave cylinder keep going bad?

What are the potential causes of a slave cylinder going bad 3 times in 2 months?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 04:28 PM.

Copyright 2002-2014 All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Audi S3, Ford Fusion and Acura TLX. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area. Challenger Hellcat - Charger Hellcat