|01-06-2013 07:15 PM|
I fixed my cruise today! This summer I replaced my broken stock 3rd brake light with a LED replacement. The cruise control requires a certain amount of resistance in the brake circuit and because LED are very low current it confused the cruise control.
I added a resistor made for LED automotive lighting and now my cruise works again!
|11-15-2012 05:17 PM|
|bringler26||I don't believe in remote starts|
|11-15-2012 04:46 PM|
|DerbyDave||The cable is supposed to be like that|
|11-15-2012 11:15 AM|
|gondorian||My cruise also doesn't work. I was poking around under the hood and I noticed that the speed control cable is loose. Maybe this is connected?|
|11-14-2012 07:09 PM|
|DerbyDave||No auto start here, The car is bone stock|
|11-14-2012 07:01 PM|
|Eastwood||if you guys have auto start engine alarm installed - you need to forget about cruise control ;)|
|11-14-2012 04:14 PM|
|DerbyDave||I doubt it's the steering wheel buttons when I do the built in self test each button responds with a flash from the cruise light.|
|11-14-2012 03:05 PM|
|bringler26||I have the same problem. Haven't been able to fix it for 3 years. I have replacement buttons for the steering wheel to try. I have a feeling that the contacts in the buttons are worn out or have too mucch dirt in them. I have an 03 zx3|
|11-14-2012 12:27 PM|
Cruise Control not Working
I have a 2002 ZX5 with manual transmission and the cruise is not working. I have gone through the self test that I found outlined elsewhere on the site and that does not reveal any problems. I have also checked the fuse and switches on the brake and clutch and those are at least being depressed when the brake is off and the clutch is disengaged. The strange thing is that I have gotten the cruise to work a few times but there is no pattern to why it will sometimes work.