|11-07-2012 09:44 AM|
So i guess the question now is, where did everyone put their ballasts and harnesses?
|11-05-2012 12:05 AM|
I have several of their kits. head (low only) and fog on my focus, hi/low on my bronco, and had low on an escape. they work great and have a lifetime warranty. I had a ballast go out on one of the headlights in the focus. contacted them and sent it back and received a new one. total time from contact to reinstall was a week! Only isue I've had is when it's really cold they may not start up the first time you turn them on; hit the switch a couple times and works fine. I would also recommend getting the power harness for them for added reliability.
Overall they are great for the money and include lifetime warranty. I would recommend them to anyone (and have several times).
|11-04-2012 11:15 PM|
|11-04-2012 11:13 PM|
|11-04-2012 11:12 PM|
|11-04-2012 10:07 PM|
|PSUrivie||I using the 55W DDM kit with in my halos. They have actually been really reliable. I've had them installed for over 2 years with no issues. I did install the relay harness with them.|
|11-04-2012 08:17 PM|
|Baldurs390||having issues with my ddm tunning today... when i switched them off they didnt turn off... had to pull the relay for them to go off... never had this prblem before but may be worth going to morimoto...|
|11-04-2012 07:11 PM|
I would never buy DDM again.
I only run Morimoto ballast and bulbs.
I ordered a DDM kit for my mothers car. Flickering, long warm ups, bulbs would fail to ignite.
I have 2 morimoto kits on my truck, 1 on my car and now 1 on my mothers car.
|11-04-2012 01:32 AM|
Ive never had a problem with DDM I had their kit before I retrofitted to Morimoto MiniH1 projectors. I had their raptor kit in my old car when I sold it never had a problem and I current have them in my motorcycle going on 1.5 - 2 years with no problems.
There are two ways to do this:
1.)One way is that you have to purchase a relay harness that has a connector that goes to one of the factory H13 connectors then into the relay which then separates into wires for both ballasts which then you connect to the ballast then you connect the HID bulb to the AMP connectors coming from the ballast (easiest way but you have to buy a H13 relay harness with your H9 HID kit if you are buying them for the Eagle Eye projectors).
2.)Sometimes they don't come with connectors just male spade terminals (like my motorcycle kit), or you pull the pins on the connector it comes with, then you just plug them into the factory connector (H13 in this case) making sure to get the polarity right (just plug them in, connect all of the other connectors, & bulb and test to see if it comes on if it doesn't just swap the spade connectors and re-test if it still doesn't work check all other connections and re-test) then you would have to use some electrical tape to seal up the connection.
Either way its a fairly easy install but that might just be me because I've hooked up so many kits lol. Im working till 5pm CST tomorrow but I might be able to take some pics tomorrow to help out
|11-04-2012 01:18 AM|
|mysticfocus||I have the 35 watt bulbs in my headlights and fogs going on almost 2 years straight and the only problem i have had is the ground on one wire pulled loose somehow and i had to solderer it again but other than that great!!|
|This thread has more than 10 replies. Click here to review the whole thread.|