|11-07-2012 02:46 PM|
|nickstewartroc||I have the same issue with mine with the K&N on a 2011 SE. I had the same exact problem when I had the FSwerks cold air, when you hit 1500rpm it struggles. I have a tuner from Tom, just have to find the time record my driving so he can make me a custom tune!|
|11-05-2012 12:25 AM|
|miscreant||That causes me a dilemma then....get a flasher and tune, or get an exhaust...|
|11-04-2012 10:33 AM|
|indy_11||from the people i've talked to with tunes, they say their car runs fine. the people without tunes have this issue. i even had it when i took the airbox resonator off. i wish i could get a tune so i could tell you if that is the case, but i'm low on funds|
|11-04-2012 10:30 AM|
|11-04-2012 01:28 AM|
When I e-mailed K&N the person that was helping me decided to send me an MAF harness that should work, so it sounds like she thought that was the issue too.
I had reset the ECM again and let it learn the idle trim again and it fixed the problem mostly, still does it a bit but not as bad. I'm going to install that MAF harness and see if it does the trick.
|11-03-2012 08:37 PM|
Memory is a bit fuzzy here but wasn't there a difference between the 05-07 and 08-11 MAF tubes? Steedas SRI kit came with a removable insert of sorts for this reason?
K&N also had issues with their MAF tubes being off in diameter, throwing off the MAF reading a bit. Perhaps this issue is present with this intake as well?
I wouldn't think you would need a tune to deal with just an intake. You are not drastically changing anything from stock except a more direct, and free flowing path of airflow to the engine and the cars adaptive learning strategy should be more than able to compensate.
I would start by making sure everything is tight. Make sure the MAF is in the right way. If those conditions are met, I would pull the MAF out and look at the sensor wire in it and see if it has been contaminated by the filter oil. If its oiled too much, oil film can make its way onto this wire, bake on it and cause bad readings. Take some special MAF cleaner to it if you suspect its dirty at all.
|11-02-2012 01:52 AM|
|miscreant||So tuning it, either getting it professionally done via Tom, or getting a flasher from say FSWERKS will help alleviate the problem?|
|11-02-2012 01:07 AM|
|indy_11||it's happened before to alot of ppl on here. my focus is a manual but when i'm in a 3-5 and at a low rpm it starts to sputter. thats just the nature of not having a tune i suppose.|
|11-01-2012 04:34 PM|
|miscreant||I kept it disconnected while I was installing it, which took an hour or so. Ahh I see what she was talking about, she didn't say T-Vict, she said PZEV.|
|11-01-2012 04:22 PM|
yeah you dont have a tivct engine.
did you leave the battery disconnected for 10-15 minutes to reset the comp?
make sure everythings tight. if you want to see if its tranny related just swap back to the stock setup for a few days to test.
|This thread has more than 10 replies. Click here to review the whole thread.|