|01-26-2015 11:36 PM|
|MarsSVTF||I got my self 2 new key remotes on ebay and they work great! $14!|
|10-30-2013 09:16 AM|
|steve08||will this operation cancel the first key. thanks|
|09-28-2013 11:32 AM|
I've tried this process and had some major problems which I'm going to need some help with!
I bought a 2001 Ford Focus (UK Car) with two keys, one worked the doors with the three button controls and also started the car and the ignition. The other opened the door as a key (not the remote) and went in the ignition but would not start the car (dash lights came on though)
I tried the process of key back and forward 4 time as described on page one of this thread with the non working key and it made the buttons on the previously working key not work. I then tried the working key in the ignition and now it won't start the car either.
I have tried to repeat the process from page one with the previously working key and it's back working the doors with the remote but still no ignition!
The key looks like this:
Nearly resolved - Some help still required
(Left original post as it may help someone)
It would seem that there is some sort of security feature that locks out the immobiliser for a period when a non programmed key is inserted.
Can someone help me make the two keys work the same?
Unlocks car as a key
Unlocks car as a remote
Turns off immobilser so car can start
Unlocks car as a key
DOES NOT Unlock car as a remote
DOES NOT Turn off immobilser so car can start
|09-16-2013 09:21 AM|
The ignition key has a transponder chip that the car reads in order to start (passive anti-theft system, or PATS). Without the chipped key you are SOL. If you have a key cut it will work on the doors but unless you spend the bucks to get a chipped key programmed to your vehicle, you won't get the car started.
The remote has zero effect on your vehicle's starting ability.
|09-16-2013 09:10 AM|
|09-04-2013 07:19 AM|
|andysvision||Hello i have a 2006 focus and i want to switch my non fliping key with a 2008 fliping key witch i will buy on ebay,can this bee done or this keys use different chips and frecuences?if yes,are this the steps i should follow thanks :)|
|07-09-2013 05:52 AM|
I have similar problem than Hillbagger. I never had any problem programming the key in my focus 07, but after some years I tried to program a new key and it is impossible to enter in programming mode. I folllow the procedure step by step and it's impossible. I did it with all keys I have and the result is the same. When I should receive the "beep" there is a quickly message shown in the frontal panel "steering assist failure" but it keeps less than a second and it disappears. After it, the car never shows me any error message.
I will apperciate any help.
|06-19-2013 04:15 AM|
Newbie here - so, sorry if I'm diving in and posting in the wrong place. Having tried all of the above re. programming a key fob for my 2008 Focus Style 1.8TDCI - I never get a 'bong' after turning the key to position II x 4 in 6 seconds. I've tried variations i.e. position I to position II / position 0 to position II but still no 'bong' - and red light on dash keeps flashing. I'm normally pretty good at fiddling about with things but this just isn't working for me. Any suggestions gratefully received.
|05-27-2013 02:05 AM|
|05-27-2013 01:55 AM|
|This thread has more than 10 replies. Click here to review the whole thread.|