|01-29-2015 09:00 AM|
If so, that is because of the error message you get. I had the same issue, fixed now.
|01-28-2015 02:49 PM|
|tnygigles66||Anyone have any info on how to install the H1 high beam?|
|01-23-2015 07:46 PM|
|Mazdamike0831||Idk I'll check the grounds tomorrow... maybe just enough contact to keep them on but not enough to make the initial fire up happen...idk I'll keep you posted|
|01-23-2015 07:09 PM|
|TheHumbleGeek||Hmmm, not sure about the message... But yea, thats the way ALL fogs are supposed to function...|
|01-23-2015 06:46 PM|
|Mazdamike0831||Factory fogs turn off when your high beams are on...only come on with low beams... yes still getting the bulb out message but only when I actually turn the headlights on.. parking lights and lights off no message|
|01-23-2015 06:33 PM|
|TheHumbleGeek||Still getting flashed? Whats the part about fog lights=low beams?|
|01-23-2015 06:18 PM|
|Mazdamike0831||Think I've got them adjusted properly now... thanks for the help!!!! Still getting flashed wtf... fog lights=low beams|
|01-23-2015 04:18 PM|
|01-23-2015 02:28 PM|
If memory serves, 25ft away on level ground, then measure from center of projector to ground, and make your line on the wall at the same height. Cutoff should be no higher than the line.
Google search will give much better instructions than I could.
|01-23-2015 10:42 AM|
|Mazdamike0831||^^^ ya have to do that today had a few people flash me yesterday... how far away from my stationary object do I park the car...also how high up the wall is right for the cutoff line thanks...|
|This thread has more than 10 replies. Click here to review the whole thread.|