|02-09-2013 03:16 PM|
|rallynut||next time get a serpentine belt tool from your local parts store. just dont use it as a breaker bar|
|10-14-2012 08:19 PM|
|klondike jake||I GOT IT.i want to thank every one for your help. i feel kinda dumb,but it just needed more force than i thought to get it to finally go. thanx again.|
|10-14-2012 01:31 PM|
Wait.... are you on the bolt inside the actual pulley, or on the bolt holding the center of the tensioner arm? You should be on the bolt in the center of the actual pulley itself, moving it clockwise will rotate the pulley up so that you can slip the belt off another pulley- usually an idler where the back of the belt rides on the pulley.
As far as belt routing, you'll have to use your head on that one. If moving the pulley up and away puts more tension on the belt, then that's obviously the wrong way to go. You might want to check to be sure that your belt routing matches what is in your manual, or at least draw it out on paper before you remove the belt.
Did someone remove AC from this car or something?
|10-14-2012 12:30 PM|
|klondike jake||moving it back towards the back of the car ,i have zero movement.is it possible that it could have been put on diff to accept a diff belt.|
|10-14-2012 03:12 AM|
I just did mine because I was changing the timing belt.
How much leverage to you have? (I had about 12 inches)
|10-14-2012 01:29 AM|
|klondike jake||dosnt want to move any when pushing towards the rear of the car.|
|10-13-2012 10:22 PM|
From underneath the car, with the wrench hanging down from the bolt.....
You're pushing the end of the wrench to the rear of the car.
Essentially trying to tighten the bolt will tighten the tensioner against it's internal spring.
That gives you some slack in the belt.
|10-13-2012 08:35 PM|
|klondike jake||are you pushing towards the front of car or towards the rear. it wants to go towards the front but it will stop within 1.5 inches of travel.|
|10-13-2012 08:10 PM|
Jack front end up
Remove right front wheel
Remove the plastic panel under the belt from underneath.
An offset closed end or flare wrench won't slip off the nut.
Then from underneath push wrench (with extension) toward rear of car.
You can the slip the belt off the crank pulley.
|10-13-2012 07:51 PM|
I use an open end wrench (I think 15mm?) with a breaker bar attached to it (Usually have to tape it to it so it doesn't slide off). And then position it in place and push forward (counterclockwise of course).
Have you tried spraying some PB Blaster in there? Sometimes it feels like you're not really moving it much but indeed you are. Maybe get someone to test the tension on the belt while you try? And have you done it before?
oh yeah, and to Focus Fanatics!
|This thread has more than 10 replies. Click here to review the whole thread.|