|Car Audio, SYNC, MyFord Touch & Electronics The Forum for the Ford Focus audiophiles. The place to chat about automobile sound systems, security systems, or show off your I.C.E.!
Sponsored By: GT Sound Control
|Topic Review (Newest First)|
|10-06-2015 10:54 PM|
Figured I'd post up in here because I saw some people asking about the Ford amp turn-on voltage pop issue. Yeah, it's been awhile. But someone may be reading this in the future.
Just like some of the earlier posts have said, you need to cut that 12V remote turn-on voltage in half (the Ford amp actually looks for 5V, but 6V is plenty close enough). You can do this a couple different ways.
1) A transistor/voltage regulator can be had from an electronics store for a buck or two. Usually just three connections. Voltage in, voltage out and ground. There's many different regulator numbers that would work for this. You'll have to hop into your local shop and ask someone. The L7806CV works perfectly, but will require a soldering iron and a little skill.
2) A single resistor in-line the remote wire. This doesn't actually reduce the voltage at all. It reduces the large current spike when the amp kicks on/off. If the resistance is high enough, it will usually work well enough to make the pop inaudible. I recommend 3k ohm or above.
3) The final method is a voltage dividing network. It's just two resistors of the same value oriented in such a way that half the voltage is shunted to ground and half to the amp. This truly reduces the voltage presented to the factory amp and is recommended over option #2 above.
So for example, you could use two 3k ohm resistors (or 2k or 4k or 5k, it doesn't matter). Vin is the blue/white remote turn-on wire from your new head unit. Vout is the factory amp turn-on connection. The symbol at the bottom is ground. Yes you can just tie right into the ground you used to wire up the new head unit. And obviously soldering these connections together is highly recommended. Insulating them with tape/heat shrink is a must.
I have personally used all 3 options many many times in many different Fords. They all work.
|10-06-2015 02:56 PM|
|loud519||Thank god I found this!!! I was freaking out when I lost my subwoofer! Sounds great!|
|08-02-2015 12:25 PM|
|Jstgilstrap||Just a head unit. I figured it out. the connectors I was using to connect the amp + and - where not making a good connection on the rca. soldered on some bigger wire and the connectors where able to make a good connection and it works.|
|08-01-2015 04:40 PM|
|08-01-2015 01:43 PM|
Opening up a dead topic. So i got the same humming that some of you got but I did not see a fix for it.
|12-28-2014 04:25 AM|
|12-27-2014 12:05 PM|
Got Around To Wiring My Sub As Indicated Here!
I just got my SVTF 4 months ago and was getting around to doing this. I finally did it today and it works great! Only thing is that I cut the wrong white/black wire and was getting a humming sound when connecting the sub. When I realized my mistake and used the right white/black wire, all was good. I mounted a Kenwood KDC-BT755HD HU if anyone would like to know. Thanks for the write up!
|09-18-2013 03:59 PM|
|twiggss||in for later|
|08-01-2013 06:45 PM|
|kwg2371||bump for the newbs|
|10-28-2012 07:34 PM|
|rdaex||Ill be doing this soon, just picked up the Pioneer DEH4400HD for 68 bucks!!|
|This thread has more than 10 replies. Click here to review the whole thread.|