|10-08-2012 11:57 AM|
Edited the photos post with direct links
the old links were from my photos in the gallery, I figured that would work. Still a rookie here.
|10-08-2012 11:22 AM|
|10-08-2012 10:14 AM|
Where the old scoop was mounted, you can see the new tube position underneath
The tube going to the 5-inch square scoop which is mounted just to the left of the fan assembly
And here's the piece to deflect the air off to the right towards the filter
|10-07-2012 04:33 PM|
Datalog IAT's and then post back.
Last night I averaged 90°F while idiling. Took about 1 minute for IAT's to drop near ambient once moving, but still 10°F over ambient. Outside temp last night here was around 30.
|10-07-2012 09:43 AM|
|Jaketet||You're right, and I know that the drop in panel filter is considered to be the best intake mod for the SVT, but I learned about that after I bought and installed my short ram, so, before taking it out and putting the stock back in and wasting my money, I'm seeing if I can do anything to prevent this horrible heatsoak that I hear about. The thing is, so far I have ever experienced any signs of heatsoak at all, I think some people are just slightly paranoid about it.|
|10-07-2012 06:14 AM|
|iminhell||Sounds like the hard way to not improve upon the stock airbox ...|
|10-06-2012 10:17 PM|
|SVTFocusOnMe||Interesting. I'd like to see some pics.|
|10-06-2012 03:36 PM|
Custom Intake mod
I'll try to post pictures soon.
Similar to the "fog light ram air" thread I found, except I still have my fog lights
I wanted to help negate potential heat soak with my K&N short ram so I modified the old air scoop that is normally up front above the grille. I moved the tube down to behind the lower grille. I found 5-inch square tube for more volume. Because the other end of the tube is not directly below the new cone filter, I riveted a piece of sheet metal to the intake heat shield to direct the air over to around the filter.
Tests with a fan showed that there was some serious airflow circulating around the filter.
Not looking for a "ram air" effect from this, I knew it wouldn't actually create any pressure, but more fresh air should help lower AITs a bit.