|09-17-2016 12:46 PM|
Great work!!! Step by step. You should publish your own "Chilton" manual.
By the way, what software are you using for the parts diagrams at the beginnng?
|04-29-2015 05:26 PM|
|ZTWFan||Does anybody know what size the bolts are for the rear, front lower control arm (dog bone ) on my wagon? I has to cut one bolthe off because it was seized to the bushing sleave. Ford doesn't carry them anymore.|
|04-10-2015 06:04 AM|
Best guide on the net! Thank you!
Did you do final torques on the front lower control arm bolts before you attached the knuckle? While it was just floating?
|03-14-2015 06:14 PM|
|03-14-2015 06:13 PM|
Got me, should have waited 'till the rain stopped to check the size.
Tx for the look up & correction.
|03-14-2015 05:59 PM|
|03-14-2015 02:34 PM|
So low you'd need an inch/lb wrench to measure. (92 in/lb. max. is std. value for 6mm.)
Snug tight with finger pressure, if you grab a wrench & reef on it with your whole hand you'll break them off.
I assume you mean the strut mount bolts, the only top mount with three.
Edit - Miztaken I am, 8mm not 6mm so they're good snugged by hand.
|03-14-2015 02:22 PM|
|LarryTate||Whats the torque specs for the 3 mount bolts (top) on the shock?|
|01-28-2015 10:20 AM|
|01-08-2015 10:39 AM|
|This thread has more than 10 replies. Click here to review the whole thread.|