|10-08-2012 09:07 AM|
|10-07-2012 09:13 AM|
|all4focus||It can be even easier than that! I gained one or two mpg just from removing the snorkel and resonator from the stock intake. Sounds better and is a bit more peppy too.|
|10-07-2012 03:40 AM|
For someone with a dally driver who just wants a couple of extra mpg this mod is a no-brainer. Buy the filter (pref with the radiused inside area...bellmouth)...remove the top of the airbox...install the filter. You're done.
I've had one of the cheaper brands...probably Spectra on two cars and I use a K&N cleaner/oiler kit...and it's still in good condition.
If you run "fast and furious"...buy the expensive stuff...and have it anodized?
|10-06-2012 09:02 PM|
|bumble21||Honestly DO NOT PUT a spectre filter in. I just switched back to the OEM box with a snorkel and it sounds better (spectre sounds like rice) and performance wise I get better gas mileage. K and n filter as well|
|10-06-2012 11:02 AM|
|FLYLOW||if your going to do this atleast do it right... spend the damn $40 and get a K&N or aem dryflow... why go with a cheap spectre or autozone one? and NO!!!!!!!, a filter is not a filter. Materials, designs, gains, end results and warranties are very different|
|10-06-2012 02:10 AM|
I got a 5% (2 mpg) gain from installing a similar cone filter in the same place....but you'd want one with a bellmouth molded inside....
The OEM intake is restrictive even if you have the resonator removed. The OEM airbox has a straight pipe intake.
Intake temps as measured from the IAT thru a ScanGauge are only a few degrees above ambient.
* you need that piece of foam in your box in the upper left corner to filter the intake air for the PCV system?
|09-16-2012 09:57 PM|
|calebstubstad||Can you post those pics? I wanna see this. Or a how to of sorts? I have a limited budget, but enough for a decent spectre filter and stuff|
|06-20-2012 05:23 PM|
I am currently running the Spectre Filter on my stock tube. So far I have not had any problems with my setup. I will be cutting the stock intake box and making it into a heat shield.
Measured it all out and it will fit. Will post pictures later.
|06-14-2012 11:16 AM|
doesen't get much better than this.
|06-14-2012 12:59 AM|
|rics94svtbird||add the cone filter from auto zone and get the cryo2 system best way or thats what im thinking|
|This thread has more than 10 replies. Click here to review the whole thread.|