|08-11-2014 01:40 PM|
Not sure what depth is needed, but ...
|08-11-2014 01:11 PM|
|BigJay||Hi, Yea re-using the brackets is what I was trying to do however it seems the lip on my speakers (where you screw them in) rest on the raised thin lip of the bracket, I tried to remove the lip on the bracket however it didn't come out clean. The bigger problem was the basket for my new speakers is just a hair too big to fit in the opening of the re-used bracket, I'll post some pics tonight of what I mean...|
|08-11-2014 07:18 AM|
You would either need to use aftermarket spacers or mount the new speakers to the destroyed spacers from the OEM speakers, but 6.75's should work.
If you are soldering, I wouldn't see the speaker gauge being an issue.
|08-10-2014 04:54 PM|
Hey guys, I'm trying to replace my focus' speakers with new coax speakers. I purchased 1 set of focal pc165 for the front doors and 1 set of JL c2 650's for the rear door. I just finished removing the door panel and moding the bracket but it seems like no matter how much i cut back the bracket the speakers don't seem to fit! Are these speakers 6-3/4"? is that why? Can I buy an aftermarket bracket that will work??
As well I was trying to use 16GA wire to connect the speaker to the bracket connection points and seem to be having a tough time soldering the wire on, should I be using a lower gauge wire??
|07-31-2014 06:21 PM|
|07-31-2014 06:18 PM|
|Firefly81||Awesome. That's what I figured I would need, just wanted to confirm. Thanks so much.|
|07-31-2014 06:15 PM|
|BrianR815||Okay I misunderstood, sorry about that. I would just use 1 inch self tapping screws, something like this. http://www.amazon.com/gp/aw/d/B004XM...ref=mp_s_a_1_1|
|07-31-2014 05:54 PM|
For now I'm going to use the stock speaker bases. If I have a rattling issue, I can always go back and fix it with the aftermarket spacer later.
I know to reuse the stock screws to mount the base to the door. I meant what screws should I use to mount the speaker to the base?
|07-31-2014 05:47 PM|
|BrianR815||If using the stock bases, I would reuse the stock screws or the new speakers may even come with screws. But personally what I do is use a spacer which is mounted and sealed to the door. Then mount the speaker to the spacer using appropriate length screws. The idea is you want to decouple the speaker from the door to prevent rattles and improve sound quality.|
|07-31-2014 05:31 PM|
|Firefly81||Thanks. I actually went ahead and ordered them anyway figuring that I can make them work. I will be putting them in tomorrow night. Any suggestions on what screw type/thread to get to screw the new speakers into the old speaker bases?|
|This thread has more than 10 replies. Click here to review the whole thread.|