|Car Audio, SYNC, MyFord Touch & Electronics The Forum for the Ford Focus audiophiles. The place to chat about automobile sound systems, security systems, or show off your I.C.E.!
Sponsored By: GT Sound Control
|Topic Review (Newest First)|
|05-12-2015 10:25 AM|
|BryFin83||Im wondering how to do this also...|
|04-20-2015 09:19 AM|
|stojan||Yes, I would also be grateful if you posted the pictures again. I really want to try this on my Focus. And, of course, congrats for the great write up!|
|04-06-2015 12:03 PM|
hello, i am guessing you will not read this considering your video is 3 years old but i am trying. so i am trying to do this on my 2005 zxw for a road trip. but the pictures provided for the wiring instructions are not viewable im wondering if you can help me. please
|03-21-2015 08:07 PM|
This is my hack, very similar to above...
1x 5V switching DC-DC converter: https://www.pololu.com/product/2177
1x Cigarette lighter replacement: http://www.amazon.com/BOSS-Audio-MUS.../dp/B00IBDSFAU
Heat shrink, varous sizes
2x male 1/4 push terminals
I was also incorporating a PAC line in box so actual process will vary.
Cut the USB terminal off the BOSS audio at the desired length, relatively short. Using your DMM determine pin-out. (Red +5v, Black 0v, Blue chassis GND). Tie back the data lines.
Splice into the output of the DC-DC, make connections as you wish (there is still much debate over crimp vs. solder). Terminate the 12v side of the DC-DC with the male push terminals.
I also incorporated a PAC Audio line in box, and made the same also connected that the cigarette lighter circuit. Using push terminal piggy backs.
** reduce the ligher fuse to 5A ** Do not keep the stock 20A.
|03-19-2015 04:05 PM|
|skeets||nice one ^^^|
|03-13-2015 07:55 PM|
That piece replaces cig lighter with usb aux and no soldering. Can be had cheaper on amazon or ebay
|03-13-2015 12:42 PM|
|djwrg04||Wow, great writeup however I wish that the pictures could be put back up.|
|07-01-2014 12:00 PM|
For those of you that are having trouble like me trying to figure out just how to cut and solder the cut USP wires to the Juke USB Interface (wiring pictures are missing) I have done some search and found this little jewel:
Looking at the pictures it looks like it will work but I have an email in to the installer Tech Dept to make 100% sure. Once I hear word back I'll follow up on this post.
PS: If you cannot use RCA jacks and need a 3.5MM for the AUX connection then then have a look at this:
|06-30-2014 09:18 AM|
GREAT POST!! Only issue is that the two phots below do not show. I have my USB/AUX port and I am ready to install but for the life of me I cannot figure out where to solder the USB wiring. Can you repost?
4. Solder the wires:
|06-15-2014 07:23 PM|
Unfortunately, the pics do not show for where to wire into the juke plug. Does anyone else have alternate links so I know how to wire this in? Also can the USB 5v just be powered by a 12v source?
|This thread has more than 10 replies. Click here to review the whole thread.|