Ford Focus Forum, Ford Focus ST Forum - Reply to Topic
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum > Ford Focus Racing Discussions > Drag Racing > Anyone race their 2012 yet...

Drag Racing The place to discuss information about drag racing stats, tips and events. Track sanctioned events only.

Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Thread: Anyone race their 2012 yet... Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-05-2013 01:49 PM
Juicedz
Quote:
Originally Posted by lyonsroar View Post
Sometimes we must admit that we have a slow car designed for maximum efficiency while sacrificing performance. We still have style though! We still have style...
Well said sir, well said!
05-27-2012 12:51 AM
VTwin60 The new DCT and PCM update make off the start throttle response much more crisp and instant instead of the long delay before it would take off. Im not sure how much if any this will effect the 1/4 mile as a whole, but it can't hurt.
01-20-2012 01:57 AM
lyonsroar Because slowcar.

/werd
01-19-2012 09:53 PM
mac.mogul Normal cars run normal times haha just a fact of life.

My V6 auto mustang ran a 16.5 @83mph when it was stock. 6 years later after intake, tune, exhaust, wider wheels, stickier tires, tightened suspension, rear seat delete, and 91 octane it ran a 15.7 @88mph. LOL Even after all that it was still just a tick away from a stock manual mustang.

I'll be taking my Focus to the track this spring and I am hoping to hit a 16 dead, maybe 15.9 if I don't totally botch the launch.
01-19-2012 09:43 PM
lyonsroar Just to compare, my 4 cylinder Fusion runs high 16's in stock form. I hope for low 16's maybe high 15's with every single power modification available done to it.

Sometimes we must admit that we have a slow car designed for maximum efficiency while sacrificing performance. We still have style though! We still have style...
01-17-2012 06:53 PM
thejsx Can't wait to race mine... I expect hi 15 as well, feels like my old crownvic when it was stock which was doing 15.8-15.9... and later with a 5 speed hi 14s!
01-16-2012 09:06 AM
Pennut
Quote:
Originally Posted by lscrx View Post
The Mazda3s is the only Focus competitor that can beat it in a drag race, and it has a 2.5 liter engine. C&D ran a 15.9 with a 5MT SE sport... that's not much slower than a '95 Mustang GT.

Posted via FF Mobile
Here's that article. Pretty good times. Almost wish i would've gotten the 5 speed manual over my powershift auto.

http://www.caranddriver.com/reviews/...ck-test-review
01-09-2012 02:16 PM
st falcon
Quote:
Originally Posted by Joeywhat View Post
Automatic or manual? I found with the auto, the 'select shift' mode allows you to keep the RPM's at 2500-ish RPM with the break pressed firmly. Basically brake torquing except there's there's no torque converter.

If you do it right you can get a bit of wheel spin when launching. I've only done it a handful of times and it's difficult to get just right. I found just flooring it and letting the RPM's sit at the 2500 mark then letting off the brake doesn't always work well.

In either event...that should help with times. I know mine is painfully slow at lower RPM's, but makes good power up high. I'm hoping for some basic bolt ons or a tune will help with the low end.
Since the DCT disengages the clutch when the brake pedal is depressed, you should be able to rev it to the dis engaged rev limiter, then quick release the brake, re-engaging the clutch(es)...kind if like an automatic's powerbrake combined with a manual clutch-dump..
01-01-2012 07:59 PM
badazz2010focus Damn fbw it's not as noticable in a 5spd car though.
12-27-2011 12:28 AM
sleepyboy They are close, real close, from what I hear. So does anyone make a header for these cars yet? I know the bolt on market sucks compared to what it was when the first gen was released, and it wasn't that big with the first gen. I just hope the aftermarket makes more parts for these, I think these foci will be damn quick with bolt on's.
This thread has more than 10 replies. Click here to review the whole thread.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 05:34 PM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Cadillac ATS-V, Ford Fusion and Acura TLX. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area.