|10-17-2011 07:56 AM|
Glad to see this does happen,I was getting a little worried!
|10-17-2011 12:06 AM|
My best guess would be data volume and priority.
Both the gauge cluster and the OBDII connector share the SCP +/- BUS line. If the transmission rate clips then both should show corrupt data. The only time I can think this may happen is if all the PID priorities are set to the fastest (1 IIRC) and you're logging the max of LiveLink (24 IIRC). That may drive the resistance of the SCP BUS higher than expected.
Flashing the car should not cause any problems though as the data rate will not be as high or near the demand.
Try taking a PID out of the log once and see if anything changes. Or start with 1 PID and work up until you find where the gauges go wonky.
|10-16-2011 08:26 PM|
This isnt common but does happen , its an issue with the SCT software and has done it in diff cars for years
|10-16-2011 06:49 PM|
|EggYolkedZX3||My car also does this during datalogging. Not quite like that Mustang but while cruising, the speedo and rpm gauges drop to zero for a second or two. I believe its normal and nothing to worry about.|
|10-16-2011 02:21 PM|
Did the custom tune weeks ago.
This seemed like the dash was going through a series of self checks.
Things were intermittently coming on and shutting off while the datalog shows no interruption in data.
Just found a video that shows the exact same thing....
|10-16-2011 02:17 PM|
Ill tell ya, ide be scared to update the car if you have connection problems.
During an update it has a connection spike and you fudge the update?
|10-16-2011 01:24 PM|
|bespurcell||Mine never did that either.|
|10-16-2011 11:42 AM|
|10-16-2011 10:59 AM|
|BowerR64||Mine doesnt do that either|
|10-16-2011 10:36 AM|
I just talked with my friend Matt who does Dynotuning and says it was normal to see this while they tune as well.
Unsure if maybe one of My parameters I selected was responsible.....
|This thread has more than 10 replies. Click here to review the whole thread.|