|03-08-2014 05:54 AM|
left dead pedal is selfmade
|11-24-2012 07:18 PM|
The thing that always makes me wonder when it comes to aluminum pedal covers is how slippery are they?
I'm in a pretty cold climate. I haven't seen a temperature about freezing in over a month now and even the water from my shoes freezes when the focus has been off for a while.
|11-18-2012 10:34 PM|
but the focus has always been horrible for heel-toe driving.
|11-18-2012 09:43 PM|
I am very cautious about the brake pedal. That thing is difficul to drill through for a reason. There is never much pressure on the clutch or gas pedal but the brake pedal in a car can see tremendous force and has to be robust. I'm cautious about anything that goes on a brake pedal. It has to be able to stand up and IMO, must never compromise the ability of the driver to stop the car. A slip-on stamped sheet metal piece is out of the question for me.
Anyway, that's just my opinion. If all you are after is a look, then I guess they are OK. More power to you. They are not for me.
For a serious driver however, the deficient placement and size of the stock Focus pedals on the 5-speed models cannot be understated. For an otherwise nice car, the 12/13 Focus has to have one of the worst setups I have ever driven. Heel-Toe (roll foot) downshifting is possible but it has to be done very deliberately and with attention and is easy to screw up. The dealer let me drive an ST when I bought my SE and they are no different. Horrible.
I may oder the autovation pedals. I had a set on my SVT Contour which I just about wore through and liked them a lot. The only thing stopping me is that the aftermarket setup will do little to elevate the gas pedal. I would really like to see about making a one inch aluminum spacer to get the gas up a bit higher. Right now I'm in Winnie the Pooh mode... think, think, think... just mulling it over, whether I want to make a spacer myself.
Has anyone done any work on developing a decent spacer? Something which is robust enough for safety reasons and refined enough to look like it isn't a hack job? Something which raises the gas pedal up an inch or so?
It would be really nice to get that autovation gas pedal in a 1 inch thick model.
|11-06-2012 11:28 AM|
Installation was easy. Looks awesome!
|10-26-2012 02:55 PM|
here is a pic of the full set
as i said the dead pedal just isnt as good of quality as the others, you can see the rough edges and the uneveness of the pedal itself. Maybe others will have better luck than me, but it will do for now.
|10-26-2012 01:43 PM|
|ihdillon||Mine should be here this weekend! So excited!|
|10-26-2012 09:21 AM|
|10-26-2012 08:05 AM|
|elwood125||+1 on these also. Really nice upgrade for the $$$. Thanks ebay china market !!|
|10-25-2012 08:54 AM|
the rough edges are not on the outside of the pedal but in the cutout areas. Its the closest match to the "RS" pedals we have
|This thread has more than 10 replies. Click here to review the whole thread.|