|05-15-2011 03:06 PM|
|FocusBoy58||this work amazingly just tested it out myself and my cord was exactly like the one in the picture. couple more weeks ill be ready to tune and run boost|
|04-12-2011 04:34 PM|
Also, per a thread on SCT's forum, not all Xcal II's have the same equation on the flash tool. Apparently the later 'blue screen' ones are different than the early ones.
Early analog equation: (v*3)+7.35
Late analog equation: (v*13.29)+7.35
I don't think I'm allowed to quote the post from the SCT forum or I would have, and unless you have PRP you aren't allowed access to it.
|04-12-2011 03:47 PM|
|Tom||Thats the write-up I used as well. However the color code they used was completely different from the wire I purchased, so to be 100% safe, use a volt meter to make sure the wires and the pins are the same.|
|04-12-2011 03:29 PM|
Xcal2 to Innovate LM1 Write Up
If yall want to make this a sticky or put it up, this is the best install for older style xcal2s with 9pin mini din connectors...