|02-10-2015 09:44 PM|
|brianbilt||So I found this thread and wanted to coment and send thanks. My 2005 ford focus would illuminate a green abs and engine light, even with the key removed from the ignition. I found this repair to be beru helpful as I pulled mu cluster to see if there was corrosion. Atfirstglance I didn't see anything out of the ordinary. But with a pair of 5xreaders on I could see corossion bleeding into the general areas of the board in which I suspect is 12 volts. The only item that I grabbed was my gun cleaning brush in which is copper. I cleaned the terms that looked bad and wipped them clean with some of my gun solution...wow...I reinsalled and walla! Worked like new... hope it helps others... thank again|
|01-05-2015 06:38 AM|
|Tiger-Heli||Also - the printed circuit board should (on a 2002 at least) just pull off - it is held by spring retainers behind the speedo, temp gauge, fuel gauge and (if applicable) tach.|
|01-03-2015 06:01 PM|
|sailor||Easy access side seems to solve most problems that cleaning can resolve.|
|01-03-2015 10:14 AM|
Can I ask, did you clean both sides or just the rear?
I`m unable to figure out how to access the side beneath the speedo and rpm
|06-18-2014 08:00 PM|
|amc49||If they put it together you can take it apart, doing so though often requires being creative as to coming back up with alternative ways of fixing fasteners that were intended to be broken to disassemble things. Ever took apart a Playstation 3?, Brother, they do not intend for kids to be doing that...................|
|06-18-2014 06:45 AM|
|04-21-2014 09:22 PM|
|sico9512||Well done I fixed my daughters car cluster is now working fine thanks to you|
|01-25-2013 07:46 PM|
AFAIK, Ford only sells the "assembly" - so you'd have to find an electronics supply source for that specific component...
Whoever built it got the part SOMEWHERE, but guessing where? THAT'S the rub....
Engineering parts supply catalog.....
Finding a source that'll sell you just ONE....
used cluster is probably a bit easier when the time comes.....
(and as whynot mentioned, more questions REALLY need a new thread to get the best answers....)
|01-25-2013 04:43 PM|
|whynotthinkwhynot||Please start your own thread. The last post before you was 9-27-2010. You'll get better help doing that than bringing up an old thread.|
|01-25-2013 10:28 AM|
The LCD Read Out in the Instrument Cluster
I am just curious if the LCD in the instrument cluster can be replaced w/o having to buy a whole instrument cluster? So far the odometer is reading fine, but the trip reset reads of the numbers as though the crystals are getting bad in the LCD?
Thanks for any help!!!
|This thread has more than 10 replies. Click here to review the whole thread.|