|10-07-2014 10:23 PM|
Ive always used Carb Choke and Throttle Body cleaner. Comes with one of those little straws to spray through, and it literally starts coming off with each spray.
It pretty much slops right off the lights. Its kinda gross
|09-26-2014 12:02 PM|
So you all know... If you're like me and prep didn't work on your fake plastic trim and you wanted dark chrome... Make sure to do a light wet sand with high grit... Then apply adhesive promoter... Then spray vht. I ended up not doing this and it came out bubbly.
After I ended up removing the Ford badge blue color on purpose :) I like the chrome badge. Next is the inside lettering to be painted.
|09-22-2014 10:21 AM|
|FreeFocus||Ive used gas from the gitgo when wanting to redo my niteshade on my tails. Wouldn't use anything else, doesn't damage the tail light or anything. Little bit of elbow grease is all you need. Glad to see someone else does the same.|
|09-21-2014 11:08 PM|
|qweesy||If your going to be rubbing shit with gasoline wear rubber gloves also dont forget to huff some of them fumes lol|
|09-21-2014 08:04 PM|
Read this online. --- "In an effort to fight misinformation around the web regarding how to remove VHT Nightshades, I made this guide as a resource for those who want to do it right. I traded some 04/05 tails I had that weren't in the best shape for this pair that were tinted to hell, but I knew with some elbowgrease I could make these right.
What you will need:
1. Brake Fluid
2. A shop rag
3. Rubbing Compound
This is a warning: If you use acetone, nail polish remover, paint remover, or aircraft paint stripper, this can damage the tail light, creating pockmarks as it eats away at the plastic.
Step One: Remove tail lights as brake fluid will damage your paint.
Step Two: Douse your shop rag in brake fluid and start rubbin it out.
Almost immediately you will start seeing results after 5-10 minutes. Total cleaning time is about 20-30 min"
|01-23-2012 07:50 AM|
|fast*st||I suppose you could try some oven cleaner or paint stripper, though I'd try a spot on a spare or broken light just to be sure.|
|12-03-2010 03:34 PM|
|HxCThumbs||im not gonna lie gas took some work. lol sanding just sounds like a bad idea.|
|12-01-2010 10:46 PM|
acetone should be fine... i use it at work and have only melted thin plastice over time (cups and what not) i was spraying my emblems black and used acetone and they were fine... as long as you wipe it off you'll prob be fine... also you could try denatured alcohol... little nicer that acetone...
but if gas works, go for it, i hate sanding!!
|12-01-2010 09:49 PM|
|HxCThumbs||mine came off with gas just to redo it better and it worked! :0 Thanks for the wright up! i would have used paint thinner and that would have ended up well....|
|09-27-2010 07:04 PM|
|Jgrove998||Might do my tail lights now since I know I can remove the stuff. Good and simple info.|
|This thread has more than 10 replies. Click here to review the whole thread.|