|10-10-2010 09:31 PM|
|2010_SES||I haven't had any problems with that. I snugged mine up quite good and left the little rubber piece on the inside of the bracket that was already there.|
|10-02-2010 07:52 PM|
Has anyone had issues with the clamp on the shifter rotating on the shaft due to not being locked over the tab at the lower position?
No issues here but I would hate to have it spin while the wife is out somewhere.....
|07-02-2010 02:00 AM|
Ok fellas, I measured the plastic tube at your request. I must like you guys to do this in the dark at 1100pm after a really long day. I measured mine at just shorter than 2 1/2". Again, this will be dependent on how high-up you raise the cable.
However, it does seem like there is a bit of leeway for this though. I had a lot more threads I could have tightened the knob on. I just barely snugged up the knob because the first time I ended up screwing the knob too far and ended up pushing the cable back down the stick making the throws longer albeit not by much.
Again, I hope this helps you guys. Any questions just ask.
|07-01-2010 09:56 PM|
|Jbone1210||Ya I agree with you. Mine is a 07 so it's a bit different. But it def gives me some ideas|
|07-01-2010 06:33 PM|
Will try and get the measurement this afternoon. Been really busy today and about to to take my wife to the airport.
Thanks all for the comments. I really am a visual guy myself so any pics I can get my hands on help me.
|07-01-2010 05:27 PM|
|voortrek3||Good job Chris!|
|07-01-2010 03:16 PM|
|Jbone1210||ya im having a lil trouble to get it fitting right so i just moved it up a lil bit. but these pics and what you did actually helps out a lot on what i can do to move it up more to get it that much shorter. thanks for the tips and pics|
|07-01-2010 03:01 PM|
|AzPete||Thanks. Having that measurement would give a good base line along with the pics you posted.|
|07-01-2010 12:22 AM|
|2010_SES||The length of the tube would be dependent on how far up you moved the cable mount. If I could free up some time tomorrow I will try and pull it off and get a measurement for you.|
|06-30-2010 10:16 PM|
|AzPete||Good job. By chance, can you measure the black plastic tube to post how long the tube is after cutting? This would pin point the amount to cut off.|
|This thread has more than 10 replies. Click here to review the whole thread.|