|11-11-2009 05:02 PM|
Well, I keep thinking about it and I've 100% decided to stick with the SVT fabric. It will give it the most OEM appearance and if I were to go with the leather, I would have to bring it into other areas of the car so it would blend better, i.e. shift boot, steering wheel ect.
I can't wait for this to get in!
|11-11-2009 03:49 PM|
|puppetman||stick with the fabric. going to leather would ruin it. just like why you didnt use the vinyl|
|11-10-2009 10:47 PM|
I'm still debating between the SVT fabric or perforated red leather.
If I don't like the SVT fabric, I'll do the leather later on down the line.
|11-10-2009 06:32 PM|
|Buickboy||thisll turn out super pimp!|
|11-10-2009 04:08 PM|
I went to an upholstery shop that I've gone to in the past for my Pontiac Fiero GT to see if they could get me some OEM Red SVT seat fabric to redo the door inserts.
After 6 years and 4 different states, I finally found a shop that can get it!
I've placed the order and I'm just going to have them put it in.
I really trust these guys and I know they'll do it right the first time so I'm willing to pay the $110.00 for parts and labor.
They are actually going to shave off the plastic welds behind the door to get the insert out and then re-weld them back in once it's all done.
Now that I have a supplier of this fabric, I've been looking to see what else I can re-do!
|11-06-2009 10:04 PM|
|norcalfocus01||I want to do this so bad. I really need to be the gienny pig and cut up a door.|
|11-06-2009 08:59 PM|
I've been using 3M General Spray adhesive and It holds really well.
As for how, I've been cutting and tucking, but I keep getting litter tears from tugging too hard. lol
I looked all around today at 5 different fabric stores and couldn't find anything...
I think I'm going to try to special order the SVT seat cloth from an upholstery shop. That way it looks more factory. I'm starting to realize that the vinyl just dosen't look right since that color/texture isn't anywhere else in the car.
|11-06-2009 04:56 PM|
|Buickboy||yeah thats a lot of work lol. are you just cutting it to shape then tucking or are you drilling out the melted plugs that hold the door panel apart? first time i just tucked and with crappy glue it fell out. next time i separated the door panel and got it in there with the crappy glue, then used small screws to resecure the plastic... the glue didnt hold and i have to do it again! blah! what are you using for glue? ive got some 3M general trim adhesive and i hope it works. good luck!|
|11-06-2009 02:17 PM|
|RSVT170||I'm on my way to the fabric store to get some more vinyl. I'm going to try and find a a shade with more brown and less pink in it.|
|11-06-2009 11:52 AM|
|puppetman||NICE i cant wait|
|This thread has more than 10 replies. Click here to review the whole thread.|