|09-13-2008 01:32 PM|
I installed some blue led bars in my footwell and under my seats. I like it only when you can see the glow from the lights and not the lights themselves. I adds a bit of class. And i just ran speaker wire straight from my lights to my battery.
Ill get some pics up to show you.
|09-12-2008 04:51 PM|
Another idea for power for you (in case you felt like giving it a shot):
I used two vampire clips behind the dash on the cig lighter. I took those and ran them parallel to my switch for my floor neon. Very clean, keeps the dash from having a wire hanging down from it, and keeps the cig lighter open for phone/GPS/radar power.
I used 18g wires off the vampires, then everything was just run behind dash and along the carpet seam to the lamps.
|09-12-2008 05:51 AM|
^^THANKS for the Name....I need some LED's for the dome lights and such!
|08-26-2008 05:57 PM|
lights for interior
go to v-leds web, all you have to know is the bulb #'s.they have kits u can buy .If that will help.
|08-26-2008 05:46 PM|
|biomed2008||how would I change the dome lights to LEDs? Can I use a normal LED with a resistor, or are there LEDs that will fit right in the socket?|
|08-26-2008 04:26 PM|
|rebelboy6121987||i bought some leds from pepboys, and a cigarette adapter. after installing the lights i spliced all of them to together and hooked them to the cigarette adapter. i plan on getting more for the back seats so the whole interior will be blue at night. i need to figure out some locations to drill the holes for the leds though... any ideas...its a 2008 coupe|
|08-02-2008 06:42 AM|
FWIW..... When I do similar projects, I always use a separate fuse for the new circuit. The idea for fusing is to use a fuse rated just slightly higher than the current draw of the new stuff.
If you use the cig lighter fuse circuit, without a separate fuse for the new lights, the cig fuse has a rating way higher than the current draw of the lights. That means that it will take much longer for the fuse to blow if there's a short in the lights. And that risks burned wiring in the light harness, rather than a blown fuse.
You can tap into the cig fuse circuit.....but add a separate fuse holder and use a fuse rated much less than the cig fuse. A 3A fuse for LEDs is usually plenty.
|08-02-2008 04:44 AM|
I did the same with mine as skinna, I will post a pic soon. However Instead of splicing into the radio harness, I have a mini project, that once I put my gauge pod in I can finish. I wired the lights into the Dome light, so when the car turns off and the door opens the lights come on. When the door closes the lights slowly fade off.
I found that switches are a pain. You will leave them on at least once a month.
|07-05-2008 11:58 AM|
|joshfink||ya know I didn't know sanding down the heads of the led bulbs would allow for more light to disperse out... I am gonna do that cause I got like 4 LEDs in each vent ... lol sanding inside the vents is gonna suck cause I glued `em down lol.|
|07-04-2008 11:20 PM|
^^ All my pics are somewhere got to remember where LMAO. :(
But yes what you see here is a PRIME example of what it will do for you.
|This thread has more than 10 replies. Click here to review the whole thread.|