|11-12-2010 12:18 PM|
Hello, I am trying to replace the vent control. I need to take of the dash board(need to know how to do that).The clip that connects to the vent control behind the knob broke so i can't put it on defrost. How do i fix or replace,can some one help. I have a 2006 ford focus.
|05-07-2008 08:21 PM|
lol, I tried adhesives, but the problem is that the vent doesn't make contact with the dash when the clips are broken. You can't get it to seal because those clips are just floating in those gaps, and the actual trim doesn't touch the dash either. So this never worked.
Duct tape thickened these clips on the vent trim enough so that they would actually hold it in place in the openings they were to pass through. You can't see it at all, and the vent trim stays in place like new. Also, if you still wanted to pop it out again, it would be a whole lot easier to do than if you used epoxy.
|05-06-2008 08:33 AM|
oh no, more duct tape?
whatever works, but i suggest using a plastic/cold weld or epoxy rather than that evil silver tape.
its funny that i knew you were from a southern state before i looked beneath your avatar. you alabama boys really like this stuff eh? lol, im j/k here bro. if it works that is all that matters.
do i really have to sticky something that involves using duct tape?
|05-05-2008 12:37 AM|
|FocusedEnergy||Nice idea, I'm just worried what would happen to it when exposed to long instances of heat (Summer sun). But, since it's out of sight, I suppose it wouldn't matter.|
|05-04-2008 10:27 PM|
|Midnight_DevilX||too late for me! lol, although I just took the bottom off to put them back in, it was a PITA to get the actual air conditioner tubing back in!!|
|05-04-2008 10:16 PM|
HOW-TO: Fix an air vent with broken clips (2005-2007)
When you pop out the rightmost vent to paint it (2005-2007), there is a good chance that the bottom two clips that hold the trim to the dash are going to break off due to the cheaper plastics Ford started using. Because of this, when you pop your vent back in, it will be attached on the top, but the bottom will move around and come out of the dash like it's on a hinge.
I came up with a fix for this if you run into this issue, once again proving my theory that duct tape can fix most any problem.
When the entire vent assembly is out of the dash, take a look at the bottom of the assembly and follow these instructions, created brilliantly in MS Paint:
Use about 6-7 layers of duct tape. Any amount is fine as long as it doesn't come out from behind the vent trim. I did this trick with my dash and my vent has been securely in place ever since. Probably more securely than it was with those cheap ass clips.
Hope this helps someone out!