|08-13-2007 10:46 AM|
|TimHickey||mine stay in fine maybe because there newer , i love how they come out like that makes it easier to clean ...|
|08-13-2007 10:00 AM|
Did it Sunday while doing my wash, my wife was out shopping, it took 10 minutes and cost $2.02 for the parts.
|08-12-2007 02:19 PM|
|Andy04180||Yup, I did the velcro mod to mine. I got tired of chasing my cup holders all the time.|
|08-12-2007 03:55 AM|
so you could pay 13 bucks every time you threw your bottle away...lol
know ive thrown 2 ut without realising it. sit and scratch my head trying to think where it went
|08-12-2007 03:43 AM|
|Xetchx||LOL it's great. every body secretly hates that damn cup holder thing. I was wondering if I was the only one. What exactly was the point of makeing a cup holder like that?|
|08-12-2007 03:37 AM|
That's true that velcro is real reversible, goinloco1. It's a pretty nice idea. We could make this the 'cup-holder solutions thread, haha.
Anyways, I wanted to fasten the cup holders down without using any adheasives, so i chose to use those fasteners.
|08-12-2007 12:01 AM|
My wife is always complaining about them coming out with her water bottle or what ever. This should fix that problem real nicely.
|08-11-2007 11:18 PM|
i just removed the holder, cleaned it and the area it goes in good, then wiped both down with an alcohol pad. have some sticky velcro that i adhered a couple pieces of to the bottom of the holder with the other piece attached. simply pressed it down and gave it a little bit of time. now its solid and removes easily.
either way works, but the velcro is reversible
|08-11-2007 08:43 PM|
|Grimmy311||Saw this and immediately went to the hardware store and did it myself! Awesome mod!|
|08-11-2007 06:55 PM|
Fastening Cup Holders to Center Console
I came up with this idea because I lost one of my cup holders due to them not being fastened down.
Here is a quick easy mod to fasten down your cup holders while retaining an OEM look.
What you need:
Drill plus Drill Bits
Utility / Exacto Knife
Here's a photo of the fasteners. I bought them at NAPA Auto Parts
First use a utility knife to cut out a hole in the center of the cup holder (the part the sits in the hole in the center console)
Then stick a fastener through the hole and see if it fits well. Adjust the hole if needed.
To fasten the cup holders down, remove the screw from the fastener and slide the bottom portion of the fastener into the hole on the center console (while the fastener is through the cup holder). Try putting the screw back in. This should push out the sides of the fastener, making it too wide to come out of the center console.
If the screw will not go back into the fastener, widen the hole in the center console with a drill. Dont stick the drill down too far; there will be wires and stuff under there.
Here is a photo of the end result:
Let me know if anything in this write up is unclear. Also can this be put in the How-To Archive?