Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - Reply to Topic
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum > Ford Focus Tech Discussions > Car Audio, SYNC, MyFord Touch & Electronics > Metra Axxcess ASWC Install

Car Audio, SYNC, MyFord Touch & Electronics The Forum for the Ford Focus audiophiles. The place to chat about automobile sound systems, security systems, or show off your I.C.E.!
Sponsored By: GT Sound Control


Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Thread: Metra Axxcess ASWC Install Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-09-2013 05:11 PM
matmatician Yup, but I doubt that will happen. Just make sure you're using a 10amp fuse!
04-09-2013 04:57 PM
ABallew6 true, well I will try a couple. The worst that will happen is I blow a fuse right?
04-09-2013 04:55 PM
matmatician Ground wire is a bit bigger so yea, I'd say 16 is a safe bet there
04-09-2013 04:43 PM
ABallew6 Sweet, thanks a bunch. I saw 14-16s at auto zone. I'll just ask someone up there. I know I needed 16 gauge wire for the ground so, I'm guessing 16 gauge there too but I'm probably wrong.
04-09-2013 04:41 PM
matmatician If memory serves right, I believe I got the quick spliced at Home Depot, and I wanna say they were 18-20 gauge, although they may have been 20-22.
04-09-2013 03:42 PM
ABallew6 Hey, quick question where did you pick up your quick splices, and what gauge are they?

Thanks a bunch.
04-01-2013 11:05 AM
matmatician No problem!
04-01-2013 10:16 AM
qweesy awesome thank you
10-04-2012 10:32 PM
matmatician
Metra Axxcess ASWC Install

Hi All,

Couldn't find a write up for visual learners like myself, so I figured I'd make one. This is how to install a Metra Axxcess ASWC in a 2006 ZX4... Or about as close as I can come to doing it right with virtually no electrical skills. Feel free to critique, as I'm sure some folks will know how to do this better than I. Also, if you follow these instructions and mess something up, don't blame me!

First thing I did (obviously) was remove the stock head unit. Removal was pretty simple. That part, I'm fairly sure most folks can manage without pictures.

Next, I installed the aftermarket wiring harness. I just used 18-22 butt splices. Also, pretty easy. Just match up the colors unless the instructions state otherwise. (pic is at the bottom)

Now for the ASWC.
Hook up the Green and White cable from the Axxess Unit to pin 18, and the power to pin 2. Ground will go to pin 19. I just used quick splices, which worked fine for me.


This is how it should look finished:

(ignore the duct tape, it was just to keep the latches on the quick splices down)

Now, if you look, you'll discover that pin 19 (the ground for the ASWC) is not actually grounded!


It used to ground through the stock stereo, so you have to make a new ground. I believe we crimped both the new wire that now grounds the stock harness and the ASWC ground into the same unit.


There are several places you can ground to. I used the screws that secure the unit that holds the head unit in place. However, I would probably recommend the hole at the bottom of the picture that's circled. It's solid metal. You just need to find a screw and nut that will fit.



And this is what the end product should look like!


Its kinda ugly, and soldering would probably be a way better route to go, but for those of us who don't have the tools, skills, or money to go that route, this way works pretty darn well too. The Metra Axxcess AWC I used automatically detected and programmed my Sony radio functions perfectly, so unfortunately, if yours doesn't, I can't help you there. Good luck!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 10:20 AM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Audi S3, Ford Fusion and Acura TLX. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area. Challenger Hellcat - Charger Hellcat