Ford Focus Forum, Ford Focus ST Forum - Reply to Topic
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum > Ford Focus Tech Discussions > General Technical Chat > Focus Won't Start

General Technical Chat This section is for technical discussions relating to general maintenance, electrical issues, engine trouble, and recalls.

Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Thread: Focus Won't Start Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-14-2013 03:33 AM
Red01Focus OK cool, I'll look into it

I'm glad this board has been so helpful,will note this as well

don't plan to,looking to take care of everything else that was put aside

thanks again,now to just sell my extra parts to pay for the much needed things
03-14-2013 02:25 AM
Milton
Quote:
Originally Posted by Red01Focus View Post
redid the cleaning of the wires scrubbed them longer and did it 3 times,cables are much cleaner no white residue picked up some dielectric grease,also how does one go about fixing the poor crimp job? i plan on picking up new fasteners to replace the rusty one's asap
Poor crimps are fixed by cutting off the old connectors and recrimping on new connectors. If that makes the wire too short you replace the wire.

Glad you are making progress. It's not glamorous work but it is required to have a reliable car. All this hard work is why you check cabling at every oil change. You catch the first signs of corrosion before you have to replace cables.

Don't stop just because it's starting to run, bring all the wires/connections up to snuff.

Good luck!
03-14-2013 02:23 AM
Red01Focus also since it's been awhile since i drove the focus i noticed when i start it up the idle is above 1000 but flutters between that and the first mark above it after a minute the flutter decreased and sat above 1k,then after 2 minutes it was at 1k then five minutes it flutter between 1k and the line below it 8 mins it slowed and about 10 mins it sat above the first line below 1k, so curious is that normal? or something i need to track down
03-13-2013 05:42 PM
Red01Focus well she turned over hoping the issue was just poor connections,letting her run for a bit,plan on redoing the wiring for the third brake light later this week. i noticed the idle isn't as rough..not sure if it was bad gas or poor connections but my license plate and frame no longer rattle lol. also exhaust still has moisture but not as bad as the first start but i added dry gas
plan on changing spark plugs and oil asap new valve cover and gasket as well
flush radiator
any other must do's since she sat for so long?
03-13-2013 05:13 PM
Red01Focus redid the cleaning of the wires scrubbed them longer and did it 3 times,cables are much cleaner no white residue picked up some dielectric grease,also how does one go about fixing the poor crimp job? i plan on picking up new fasteners to replace the rusty one's asap
03-08-2013 06:23 PM
FocusRus 10..........
03-08-2013 06:21 PM
Red01Focus Photo 6 yeah i did the baking soda and water trick but didn't clean it up so well, will redo it again(that's the white powder) but I'm thinking I'll go with your plan to just replace it all.

Photo 7&8 yeah i never messed with them I'm thinking they were worked on when the shop redid the license plate lights but the larger cable is attached to the main cable so it would be replaced when the main cable is

Photo 9&10 I will check out the cable more to see if it needs replaced

so i will pick up the grease and new hardware, i know the cables were replaced when the starter was put in but as you said everything was done poorly so time to take care of that. again you have been very helpful milton it's greatly appreciated and bobby i will take a look tomorrow and let you know what i find out
03-08-2013 02:38 PM
Milton
Your Photos

After looking over your photos, you appear to need some additional work.

PHOTOS 1, 2, 3 & 4:
Very poor job of making connections.
ACTIONS: I would not worry about modding your 3rd taillight right now. Just restore it to the stock configuration. After you get it running then work on the mods.

PHOTO 6:
A) The entire connector seems to coated in some with powder.
B) The top cable: connector poorly crimped
C) Center Cable: The clamp plate is coated in white powder which appears to extend into the inside of the cable.
D) Bottom Cable: Poor crimp connection and powder appears to extend into the inside of the cable.
ACTIONS: Replace all 3 cables and the negative battery cable connector. When you reconnect the new cable to neg battery post use dielectric grease. Also use dielectric grease at the connection point on the other ends of the cables.

PHOTOS 7&8:
A) One cable looks recently cleaned and reattached with a rusty fastener.
B) The other cable has not had and maintenance and is attached with a rusty fastener.
ACTIONS:
1) I assume that the bigger cable runs to the battery and will be replaced in photo 6 action items. When you install the replacement use a new fastener and dielectric grease.
2) Not sure if the smaller cable will be replaced in photo 6 action items. The connection needs to be cleaned as the bigger cable is, then attached using a new fastener and dielectric grease.

PHOTOS 9&10:
I see traces of green corrosion and white powder. Not sure if I see traces of rust or not.
ACTIONS:
1) Whether or not the cables need replacing depends on whether or not the corrosion extends underneath the insulation. If it does then replace the cables. Be very critical in your assessment.
2) When you reconnect the cables (both ends) you want everything bright & shinny, Use dielectric grease & no rusty fasteners.


Good luck.
03-08-2013 09:07 AM
FocusRus Check that the gear selector when attempting to start the engine....wiggle, etc., maybe the neutral safety switch.....But, I would also check these relays and fuses:

Under hood Central Junction Box;
Relays:
R17-Starter
R1-Ignition.....any one of these could cause the issues you're having with faulty wiring to the relay in the CJB -or- a bad relay itself.

Fuses:
1- 40A....main power supply to the electrical system
7- 40A.... same as above
8- 30A...ignition switch, starter
10- 10A (2.0L) Battery Voltage Sensor......hey, that's what it says....
Check these out, if you already haven't. With the relays I would swap them around with one of the same type (pin). Also, check for voltage at R17 & R1, as well as ground. These relays should have power directly from the battery at ALL times. Usually though, the relay itself has corrosion inside.....another thing is when cranking....they will be unusally hot... Do the ford wiggle test! KOEO, KOER..blah, blah.
03-08-2013 12:04 AM
Red01Focus atx for now
This thread has more than 10 replies. Click here to review the whole thread.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 06:34 PM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Cadillac ATS-V, Ford Fusion and Acura TLX. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area.