|02-10-2016 01:29 PM|
As stated before, the acc. 12v tap by the center armrest times out after 10-15 minutes of a locked leave. Does anybody know where I can tap into this power source (or alike) before this time-out circuit? I like when it supplies power, but plan to add a shorter time-out circuit (30sec). Any other suggestions?
|02-04-2016 10:42 PM|
Sent from my XT1254 using FF Mobile
|01-15-2016 01:47 PM|
|AddedDistraction||I know this is an old thread, but I'm doing something similar and have some questions. What gauge of wire did you use between LED segments? Since these LEDs have such a low current draw, I was planning on making the majority of my wire harness out of 16 gauge copper strand, using RJ12 phone wire (26 AWG Copper Core) and jacks for segment connections. Since I have the moonroof, I decided to put LEDs in the header - back side of the moonroof opening. I'm wondering if that wiring to the roof will need to be RF shielded.|
|08-12-2015 09:06 PM|
|07-07-2014 06:38 AM|
Do you have seat covers on the rear seats? I'm trying to figure out what I'm looking at in your "shots from the back".
I like the look AND the price !
|07-03-2014 05:52 PM|
|Rizzydee||Looks good - better than Fords $250 price tag.|
|02-17-2013 01:39 PM|
I would like to add the ambient lighting to the back seats matching the front of my ST3. To complete the package that Ford forgot too.
|12-16-2012 07:21 AM|
|shineboy||Nice job, pretty sweet for only 30$|
|11-03-2012 12:11 AM|
|10-31-2012 10:20 PM|
|misfire||not bad....not bad at all|
|This thread has more than 10 replies. Click here to review the whole thread.|