|12-24-2012 11:00 AM|
|yjman92||im getting the kit when i get the problem resolved! it shall be glorious|
|12-24-2012 07:35 AM|
Have no idea what size the bolts ....what i used came from Massive. You could ask Karl at Massive sure he could tell you.
If you order his bushings it comes with the bolts..then all you would need is to fine the right nut...
|12-23-2012 06:48 PM|
|12-18-2012 12:03 PM|
If drilled straight i think NAPA or Fastenal has bolts that would fit and if needed add a few washers and a lock nut.
If mount bushings hasn't been changed i suggest Massive Purple.....Awesome!!
|12-17-2012 12:56 PM|
|12-17-2012 10:54 AM|
|84572||You might try getting a hardened bolt that fits the hole snugly or a sleeve for the hole, a nylon lock nut and a washer. Be careful not to over tighten it and break the tranny housing. I don't envy you, good luck.|
|12-16-2012 09:49 AM|
|12-16-2012 07:59 AM|
|macdiesel||I wonder if you could put a spacer or washers in the gap between the mount and the bracket to fill in that gap. I know it looks rigged, but maybe just the mount is bad. Can't tell from picture but looks like oil type fluid is leaking on the mount,which doesn't help rubber.|
|12-15-2012 11:43 PM|
|yjman92||lmao i agree with you, the only thing is the hole has been re drilled for some damn reason, and its been redrilled at an angle all halfassed|
|12-15-2012 04:38 PM|
Looks like ready-rod.
Pull it out and see if you can just get by using a bigger rod.
The PO must have been a real smart person
|This thread has more than 10 replies. Click here to review the whole thread.|