Ford Focus Forum, Ford Focus ST Forum - Reply to Topic
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum > Ford Focus Tech Discussions > General Technical Chat > Cooling fan resistor , will my fan still work ?

General Technical Chat This section is for technical discussions relating to general maintenance, electrical issues, engine trouble, and recalls.

Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Thread: Cooling fan resistor , will my fan still work ? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-07-2012 05:03 PM
amc49 Well I gotta agree with some of that too. Ford has had a big problem with repeat issues with overheating parts on model after model in the last 20 years. This after manufacturers have known for 50 years how to design parts that won't melt. Continually screwing with smaller and cheaper components while still moving same amounts of power or more around has lead to some of this. Electricity still uses same laws now as then, it takes a certain cross section of metal to carry power, especially at connections. When you flaunt that you get fires. In short, the bean counters should take some of it, the cars are made too cheap. When I rebuilt the resistor, I made sure it would never melt again by design just as I did with the bigger battery cable I made to replace the melted OEM one.
12-07-2012 03:36 AM
Top-Ace Coming from a little experience, I wouldn't blame the engineer. The real people to blame for this type of cost cutting are the business execs who cant tell their rear end from an end wrench that the enineers have to ultimatley heed too.
The type of decision making they practice is a direct result of the buisness culture in the coorporation which is the result of the board of directors.

Wish I spoke Japanese sometimes.
12-07-2012 02:40 AM
amc49 Look how big the rest of the fan system connectors are as compared to the resistor connection, the resistor connector is smaller, and right at a heated point from resistor itself. Gotta wonder how much that engineer's college education cost......

No wonder Fords catch on fire so much, just saw another news story on it again couple of days ago.
12-07-2012 01:26 AM
Top-Ace Dorman actually makes a kit for this problem (#902-219). Must be common enough that they decided to make a nice solution. Way cheaper then going the dealer route.

http://www.napaonline.com/Catalog/Ca...010_0388666574
12-07-2012 12:31 AM
Fattie mine was solid rust , i poke it with my finger and it just fell apart. im going to get a new one , and i didnt even bother to put the fan back in , its been around 30 degrees or lower here latley and the temp gauge stays right below half , and i keep the heat cranked. I will be buying a new one in a few days. thanks for the help
12-06-2012 12:13 AM
amc49 The resistor controls low speed on both fans. High fans come on bypassing resistor at 240+ degrees or around 250+ psi highside on a/c.

Car will run with high fan only but it's a backup, you'll toast engine if that fails, the double fan speed setup is an automatically backed up system unless you insist on running it half failed. Head gasket jobs are always cheaper than resistors right?

When my resistor failed I rebuilt it and connector for like $7-$8 worth of parts. The resistor coil itself does not go bad, only the connections.
12-05-2012 03:46 AM
xxMichaelAnthony Electrical problem on the resistor side of the circuit. Both fans still come on during KOEO OBD test so its nothing in the fan circuit.
12-05-2012 01:28 AM
my_beautious_ZX3 ^sounds like there's more wrong with your cooling/electrical system than just a bad resistor.
12-05-2012 12:54 AM
xxMichaelAnthony No fans will come on without the resistor. Mine has been bad for months. No fans! But, if you turn the AC on the big fan will come on for a little bit a couple times a minute.
12-04-2012 11:37 PM
my_beautious_ZX3 that's a common issue on this forum; surprised you haven't seen it.

It's the low-speed half of the Focus's 2-stage cooling fan. Removing it reduces your cooling system to a one-speed fan that kicks on with the A/C or when the engine is on a trajectory to overheating. Of course, if your old resistor was already rotted away (open-circuit), then the fan won't even realize that you removed it.

If you haven't noticed this already, then you will start seeing the temp gauge creep over to the 2 o'clock position when you're sitting in traffic, at which point the 2nd-stage fan will kick on and the needle will creep back to 12 o'clock.

The added heat stress over the life of the vehicle certainly won't make the engine any younger, but from what I gather, many (most??) old Foci are on the road and completely unaware that their resistor died ages ago. (me)
This thread has more than 10 replies. Click here to review the whole thread.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 12:09 PM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Cadillac ATS-V, Ford Fusion and Acura TLX. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area.