Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - Reply to Topic
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum > Ford Focus Tech Discussions > Wheels & Tires - Sponsored By Tire Rack > Alignment Question

Wheels & Tires - Sponsored By Tire Rack The place to go for answers on wheel types, tire sizes, offset, wheel patterns and more.
Sponsored By:
Tire Rack


Search This Forum | Image Search | Advanced Search    
Ford Focus Tire & Wheels FocusFanatics Merchandise

Thread: Alignment Question Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-15-2012 09:09 PM
RSV 02 Focus
Quote:
Originally Posted by Geezer View Post
My opinion is that in addition to most if not all the toe settings being off the rear camber is also excessive. After lots and lots of research and experimentation with several other FF member we concluded the rear camber need not exceed -1.6 degrees for maximum tire life. You will need an aftermarket rear camber adjustment devise to lower your current settings. Camber bolts are the cheapest way are just fine for adjustments to a daily driver. There's also adjustable upper control arms which cost more but are also more precise.

Front toe should have just a smidgen of "toe-out" of about .02 degrees but no more if you still have stock rubber bushings. Go with zero toe if you have upgraded to polyurethane bushings. Rear "toe-in" should be .10 degrees. Toe is the only adjustable parameter from the factory.

PS.....You have to ask for these settings or you won't get them!!!!
I know exactly what you mean about having to ask for the settings. Went through that drill today at the alignment shop. Also read other posts where folks had the same problem.

Thank you for your response.

Roy
11-15-2012 09:03 PM
Geezer My opinion is that in addition to most if not all the toe settings being off the rear camber is also excessive. After lots and lots of research and experimentation with several other FF member we concluded the rear camber need not exceed -1.6 degrees for maximum tire life. You will need an aftermarket rear camber adjustment devise to lower your current settings. Camber bolts are the cheapest way are just fine for adjustments to a daily driver. There's also adjustable upper control arms which cost more but are also more precise.

Front toe should have just a smidgen of "toe-out" of about .02 degrees but no more if you still have stock rubber bushings. Go with zero toe if you have upgraded to polyurethane bushings. Rear "toe-in" should be .10 degrees. Toe is the only adjustable parameter from the factory.

PS.....You have to ask for these settings or you won't get them!!!!
11-15-2012 08:04 PM
RSV 02 Focus
Quote:
Originally Posted by 6SPD_soul View Post
The camber numbers are acceptable IMO, and while the toe appears to be way off at both ends of the car nothing aftermarket should be required to get it back in spec. Although the stock rear toe adjustment is just an eccentric bolt, so it's range of adjustment is way more limited than the tie rods. I'm surprised you were able to get those numbers without them talking you into getting an alignment on the spot.

I guess I don't know if the stock setup is capable of getting that right rear back in spec. I suspect it would though.
Thank you for your response. I wanted to get it checked first to see if I needed the rear camber bolts. Also, my mother in law just ordered new tires so we plan to get it aligned when they're installed. If the rear camber is OK in your opinion, it looks like we'll have them do an alignment then.

Thanks again, I appreciate it!!

Roy
11-15-2012 07:44 PM
6SPD_soul The camber numbers are acceptable IMO, and while the toe appears to be way off at both ends of the car nothing aftermarket should be required to get it back in spec. Although the stock rear toe adjustment is just an eccentric bolt, so it's range of adjustment is way more limited than the tie rods. I'm surprised you were able to get those numbers without them talking you into getting an alignment on the spot.

I guess I don't know if the stock setup is capable of getting that right rear back in spec. I suspect it would though.
11-15-2012 06:33 PM
RSV 02 Focus
Alignment Question

Hello Everyone,

First post here and I have a question. First I've read about all the alignment problems and solutions related to the Focus. In this case, it's a 2002 Focus ZTS; mother in law's car.

It ate a set of tires way too quickly so after reading some posts, I took it to an alignment shop and had them give me a printout. Unfortunately I can't scan it but here's a summary of the printout:

Left Front - Camber -1*, Caster 2.4*, Toe -.78*
R. Front - Camber -1.4*, Caster 2.8*, Toe -.82*

L Rear - Camber -2*, Toe .19*
R Rear - Camber -2.3*, Toe -1.04*

No wonder it was eating tires All 4 are shot

Now the questions:

The toe is WAY off, can it be corrected without having to go with some aftermarket thing?

The rear camber worries me - posts I've read said ideally it should be -1.4*
Is it worth my time to install the aftermarket camber bolts or can I let this slide?

Just want to put this issue to rest because my mother in law is on a fixed income but I want this done right.

Thanks and glad to be a member of the board.

Roy

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 08:19 PM.


Copyright 2002-2014 FocusFanatics.com. All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Audi S3, Ford Fusion and Acura TLX. You can find all Ford Focus and Focus ST related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area. Challenger Hellcat - Charger Hellcat