|03-02-2016 04:54 PM|
just want to add that i did this install on my Mk1 with a $50 kit. funny enough there already was a fuse slot for heated seats but couldnt trace the wire, so i plunked an add a fuse in and pressed on regardless.
ps it is similar to a fix i made on my SVT heated seats http://www.focusfanatics.com/forum/m...-seat-pad.html
the carbon fibre heating elements are way better than the single strand wire of the SVT.
|03-09-2015 09:47 AM|
|darkside212||my 2014 HB 5spd doesn't have the rear fuse box! Anyone know where it could be?|
|02-25-2015 03:06 PM|
|01-06-2015 02:53 AM|
|Focus 13||Can you feel any difference in the seat? Like can you feel the pad at all?|
|12-14-2014 11:29 AM|
|Rsaxon||are the connectors on the st leather seats same as ford focus zetec s 2012|
|03-10-2014 10:04 AM|
|bproctor||Ok I feel stupid, I used one of the add a fuse adapters and didnt realize that I had to put two fuses in it for it to work. I still dont understand why i didn't get a reading on the multimeter though.|
|03-10-2014 08:59 AM|
|bproctor||I just installed heated seats yesterday and everything seemed to go well. I seem to be having a problem with the luggage compartment fuse panel. When the seats didnt power on I went back to double check the fuses and they were good. I then put a multimeter on the fuse panel and never could get a reading. Anyone have any ideas?|
|02-12-2014 10:13 PM|
Btw, here's the other end of the seat connectors they show in the other post. And the factory heat pad.
So factory heat pad is using two connectors, one green and one blue.
It would be nice to see how someone that has factory installed heated seats' connectors line up...
|02-12-2014 09:49 PM|
Interesting. I'll have to look into the BCM, and your right, worst case, use aftermarket in place of factory switches.
So the thread you linked has a picture specifying the pins for the heated seats (for the ST). I'm not sure how he confirmed that, as in our manual, it says fuse 85 is heated seats, as well as the "passenger airbag deactivation indicator" (PADI), and some other things. I don't want to screw up the occupancy detection sensor.
And that electrical connector their showing is the one under the seat, not under the cupholder... I wonder does the power run from the fuse panel to the switches, and then to the seat connectors and pads? Or does it go from the fuse to the seat connectors and pads, with a separate wire back to the switch.?
|02-12-2014 05:54 PM|
Let us know how it goes though, I have that factory switch piece as well and was going to dive into it this summer. If all else fails you could dremel out the factory switches to mount the aftermarket ones and it would look "almost" factory.
EDIT: This whole thread might be of interest to you, it's from another forum. But I'll link to one post. Someone with an ST verified that the wiring under the seat is there, and hot. Not sure if it's the same case with a S or SE.
|This thread has more than 10 replies. Click here to review the whole thread.|